Upload
others
View
26
Download
0
Embed Size (px)
Citation preview
© Insignex 2016
1
Bootloader
© Insignex 2015
2
Boot-loader
Open bootloader
application
© Insignex 2015
3
Select program ->
Settings
© Insignex 2015
4
Set appropriate
COM-port and
Baud-rate
© Insignex 2015
5
Switch into
bootloader mode
© Insignex 2015
6
If you find this message then
1. Press USB_Reset button and again try to switch into
bootloader mode
2. Still it is showing the same message then close application ->
press USB_Reset button -> reopen application and try to
switch into bootloader mode
© Insignex 2015
7
© InSignEx 2016
8
INX-Z30
No. Part Name
10 SW0, SW1, SW2
11 LED select pin
12 Buzzer
13 NRF24L01+
14 Reset
15 Jumper J2
16 PicTail Port
17 Power LED
18 Micro USB
No. Part Name
1 Power selector
2 DC jack
3 USB reset
4 TX, RX LED
5 LCD Port
6 LEDs 1,2,3,4
7 GPIO Port
8 GND
9 Jumper J3
Board in
Bootloader mode
© Insignex 2015
9
Open
appropriate hex
file by selecting
File -> Open
© Insignex 2015
10
Press on write
device to burn hex
file into chip
© Insignex 2015
11
RUN the
Application
© Insignex 2015
12
• Once you burn program, bootloader is not
require.
© Insignex 2015
13
© Insignex 2016
14