Upload
georges-fezzany-2946
View
221
Download
0
Embed Size (px)
Citation preview
7/31/2019 BONUS - Yellow Light of Death
1/16
Yellow Light Of Death (YLOD) Fix
7/31/2019 BONUS - Yellow Light of Death
2/16
Copyright, Legal Notice and Disclaimer
The e-book and its contents are Copyright by cinaviaps3.com. No part of
this publication may be reproduced, stored in a retrieval system, ortransmitted by any other means: electronic, mechanical, photocopying,
recording, or otherwise, without prior written permission of the copyright
holders.
This e-book is designed to provide accurate and authoritative information with
regard to the subject matter covered. It is sold with the understanding that the
publisher and the contributors are not engaged in rendering legal, accounting,
or other professional advice.
The reader is advised to consult with an appropriately qualified professional
before making any business decision.
cinaviaps3.com assume no responsibility for the use or misuse of this
product, or for any injury, damage and/or financial loss sustained to persons
or property as a result of using this e-book.
The use of our information should be based on your own due diligence, and
you agree that our company is not liable for any success or failure of your
business that is directly or indirectly related to the purchase and use of ourinformation.
Please be advised if your console is still in warranty then send it back and do
not attempt this repair. The following repair is meant to fix faulty mother
boards, and does therefor not fix or repair: power supply or disc read errors.
We can in no way guarantee that the following guide will fix your console, so
by following our guide you are taking full responsibility for any loss of
hardware due to damage caused by following our guide.
Yellow Light Of Death (YLOD) Fix
7/31/2019 BONUS - Yellow Light of Death
3/16
Table of Contents
Required tools! 4Guide (step by step)! 4Putting it all together! 15
Yellow Light Of Death (YLOD) Fix
7/31/2019 BONUS - Yellow Light of Death
4/16
Required tools
The following tools are required in order to follow our instructions and fix your
console.
Heat gun
Isopropyl alcohol (Acquirable from chemist)
Phillips screw driver
Flat blade screw driver or slotted torx bit.
Vacuum cleaner (preferred compressed air blower)
Guide (step by step)
We want to remind you, if your console is still under warranty - Take it back!
1. Start by removing the warranty sticker and the rubber foot that is positioned
above the hard drive.
2. Unscrew the cover plate using either a flat blade screw driver or a slotted torx
bit.
Yellow Light Of Death (YLOD) Fix
7/31/2019 BONUS - Yellow Light of Death
5/16
3. Now carefully slide of the plate moving it towards the left until it stops and lift it
off.
4. Remove all the screws show on the image below.
5. Carefully hinge the case towards you until it detaches, now tilt it to the left as
shown below.
Yellow Light Of Death (YLOD) Fix
7/31/2019 BONUS - Yellow Light of Death
6/16
6. Next we want to carefully remove the ribbon cable. Do this by lifting the back
part of the connector.
7. Now tilt the Blu-ray drive towards the right while disconnecting the power cable
and the ribbon.
Yellow Light Of Death (YLOD) Fix
7/31/2019 BONUS - Yellow Light of Death
7/16
8. Remove the 5 screws as well as the earth wire screw. Before removing the PSU
you will want to unplug the small BNC connector (the black wire) and remove
the tape on side of the PSU. Then lift off the PSU.
9. Remove the wide ribbon from the connector, then unscrew the 4 screws on the
Bluetooth board and remove it.
Yellow Light Of Death (YLOD) Fix
7/31/2019 BONUS - Yellow Light of Death
8/16
10. Next - remove the Hard drives cover.
11. Look for the blue screw on the hard drive and unscrew it. Remove the hard
drive by sliding it towards the gap in the bay.
12. Remove the hard drive. Then unscrew the 4 screws holding the bracket (on/off
& eject control panel). Remove the small ribbon and remove the whole control
panel.
Yellow Light Of Death (YLOD) Fix
7/31/2019 BONUS - Yellow Light of Death
9/16
13. Unscrew the next 8 screws
14. Lift enclosure out of the base.
Yellow Light Of Death (YLOD) Fix
7/31/2019 BONUS - Yellow Light of Death
10/16
15. Remove the black rear panel. Make sure to unclip it first.
16. Unscrew 4 more screws to remove the sprung brackets.
17. Lift of the metal cover plat while allowing ribbons to pass through gaps in theplat without damage.
Yellow Light Of Death (YLOD) Fix
7/31/2019 BONUS - Yellow Light of Death
11/16
18. Turn the board over and remove the fan power connector and then the fan.
Yellow Light Of Death (YLOD) Fix
7/31/2019 BONUS - Yellow Light of Death
12/16
19. Unscrew 2 more screws that are holding the plate to hard drive connector and
unplug the battery connector. Then remove the whole plate.
20. Make sure to clean the old compound on the heat sink from the 2 main
processors using the alcohol. Make sure everything is cleaned! (IMPORTANT!)
21. Using the compressed air or your vacuum cleaner make sure to get rid of all
dust that builds up within the consoles case. Everything MUST be completely
cleared from dust. When you have cleaned each part you will have something
like shown on the image below.
Yellow Light Of Death (YLOD) Fix
7/31/2019 BONUS - Yellow Light of Death
13/16
22. Now check the top metal cover plate (underside) for burn in marks.
Yellow Light Of Death (YLOD) Fix
7/31/2019 BONUS - Yellow Light of Death
14/16
23. Place your consoles mother board on a flat area that is resistant to heat. Then
turn on the heat gun and set the temperature to 350 degrees. The fan speed
should be set to low. Now let the gun heat up before continuing!
24.By using a circular motion hold the heat gun over areas outlined below. Make
sure that you keep the heat gun about an inch above the board!
Hold heat gun over these parts
CPU side (for about 10 to 15 seconds)
NON CPU side (for about 10 to 15 seconds)
Marked areas on the mother board see image below. (for about 10 to 15
seconds)
On the image above there is still heat sink compound - remove before blowingair!
Yellow Light Of Death (YLOD) Fix
7/31/2019 BONUS - Yellow Light of Death
15/16
Now leave the parts for about 15 minutes and let them cool off. If you hear strange
cracking sounds - do not worry. This is perfectly normal!
Your console is now fixed!
Putting it all together
Before we put the parts back together and enjoy our fixed console we want to go
ahead and apply the new heat sink compound on to the 2 processors. We
recommend that you follow the paste manufacturers instructions when doing this.
These instructions can be found along with the paste you bought.
The paste that we used is called AKASA 450 and it is based off of silver. You can
find this in your local PC shop.
Apply paste to both processors!
Yellow Light Of Death (YLOD) Fix
7/31/2019 BONUS - Yellow Light of Death
16/16
Now we are ready to reassemble the console. To do this redo our step by step
guide in reverse. Make sure that all cables are plugged in before continuing in
each step!
Yellow Light Of Death (YLOD) Fix