Barefoot Baby Bootique Pattern Number 23

Sarah - Bonnet & Booties SetSarah - Bonnet & Booties SetSarah - Bonnet & Booties SetSarah - Bonnet & Booties Set Will fit 14 to 16 inch reborns & dolls

You will need:You will need:You will need:You will need: 50g double knitting yarn50g double knitting yarn50g double knitting yarn50g double knitting yarn 1 pair size 3.25 mm needles (old1 pair size 3.25 mm needles (old1 pair size 3.25 mm needles (old1 pair size 3.25 mm needles (old UK size 10) UK size 10) UK size 10) UK size 10) Size 3.5 crochet hookSize 3.5 crochet hookSize 3.5 crochet hookSize 3.5 crochet hook Ribbons & Embellishments (optional)Ribbons & Embellishments (optional)Ribbons & Embellishments (optional)Ribbons & Embellishments (optional) Tension: 16Tension: 16Tension: 16Tension: 16 sts to 5 cms (2 inches) over sts to 5 cms (2 inches) over sts to 5 cms (2 inches) over sts to 5 cms (2 inches) over pattern on 3.25pattern on 3.25pattern on 3.25pattern on 3.25mm needles.mm needles.mm needles.mm needles. This little set can be knitted in 2.75mm needles with 4 ply yarn to make the set smaller to fit 12 to 14 inch baby dolls.

BonnetBonnetBonnetBonnet

Using 3.25 needles cast on 72 sts Starting with a K row, st st 4 rows Picot Row: K1, #Yfwd, K2tog, rep from # to last st, K1 Next Row: P St st 4 more rows To form the picot edge, knit together the sts on the needle with the cast on edge sts to the end of the row. If you find this too fiddly, you can sew it afterwards. If you do not want to use a picot front edge, you can always knit just 2 rowsIf you do not want to use a picot front edge, you can always knit just 2 rowsIf you do not want to use a picot front edge, you can always knit just 2 rowsIf you do not want to use a picot front edge, you can always knit just 2 rowsbefore commencing the pattern, it will look just as good.before commencing the pattern, it will look just as good.before commencing the pattern, it will look just as good.before commencing the pattern, it will look just as good. Commence PatternCommence PatternCommence PatternCommence Pattern 1st Row: K 2nd Row: K2, P to last 2 sts, K2 3rd Row: K2, (K2 tog) 3 times, #(yfwd K1) 5 times, yfwd, (K2 tog)

6 times, rep from # to last 13 sts, (yfwd K1) 5 times, yfwd, (K2 tog) 3 times, K2 4th Row: K2, P to last 2 sts, K2 Repeat these 4 pattern rows 4 more times (20 rows) Next Row: K Next Row: P Next Row: K Next Row: P Picot Row: K1, #Yfwd, K2tog, rep from # to last st, K1 Next Row: P Next Row: K Next Row: P Next Row: K Next Row: P To form the picot edge, knit together the sts on theneedle with thecorresponding sts 8 rows below to the end of the row. If you find this too fiddly, you can sew it afterwards. Next Row: K Next Row: P Shape CrownShape CrownShape CrownShape Crown Next Row: K1, #K2tog, K5, rep from # to last 8 sts, K2tog, K6 Next Row: P Next Row: K1, #K2tog, K4, rep from # to last 7 sts, K2tog, K5 Next Row: P Next Row: K1, #K2tog, K3, rep from # to last 6 sts, K2tog, K4 Next Row: P Next Row: K1, #K2tog, K2, rep from # to last 5 sts, K2tog, K3 Next Row: P Next Row: K1, #K2tog, K1, rep from # to last 4 sts, K2tog, K2 Next Row: P Next Row: K1, #K2tog, rep from # to last 3 sts, K2tog, K1 Next Row: P Break off yarn, draw through the remaining sts and tie off. TiesTiesTiesTies With your 3.5mm crochet hook, make two chains 8 inches/20cms long Making up the bonnet: Sew the picot edges in place if you have not already knitted them in. Sew the back of the bonnet crown to the picot edge. Sew the crochet chains to the bottom edge of the bonnet on the front picot edge. Make some tassels or pom poms and sew them to the ends of the chains. You can always use ribbons to tie the bonnet if you wish. Embellish as required.

Boots (make 2):Boots (make 2):Boots (make 2):Boots (make 2):

Using 3.25 mm needles, cast on 36 sts Commence PatternCommence PatternCommence PatternCommence Pattern 1st Row: K 2nd Row:, P 3rd Row: K1, (K2 tog) 3 times, #(yfwd K1) 5 times, yfwd, (K2 tog) 6 times, rep from # to last 13 sts, (yfwd K1) 5 times, yfwd, (K2 tog) 3 times, K1 4th Row: P Repeat these 4 pattern rows 2 more times (12 rows) Next Row: K Next Row: P Eyelet Row: K1, #Yfwd, K2tog, rep from # to last st, K1 Next Row: P Shape instepShape instepShape instepShape instep Next row: K23 Turn Next row: P10 Working only on these 10 sts, work 8 rows in st st Break off the yarn and rejoin to instep.. Pick up and knit 8 sts evenly along the right side of the instep,

knit across 10 sts Pick up and knit 8 sts evenly along the left side of the instep, andknit across remaining sts Knit 7 rows Shape FootShape FootShape FootShape Foot 1st Row: K1, K2tog, K18, K2tog tbl, K7, K2 tog, K to last 3 sts, K2tog tbl, K1 Next Row: K Next Row: K1 , K2tog, K17, K2tog tbl, K5, K2 tog, K to last 3 sts,, K2tog tbl, K1 Next Row: K Next Row: K1 , K2tog, K16, K2tog tbl, K3, K2 tog, K to last 3 sts,, K2tog tbl, K1 Next Row: K Cast off. TiesTiesTiesTies With your 3.5mm crochet hook, make two chains 16 inches/40cms long Making up the boots:Making up the boots:Making up the boots:Making up the boots: Sew up back and foot seams, Thread the crochet chains through the eyelet holes at the ankles. Make some tassels or pom poms the same as for the bonnet and sew them to the ends of the chains. You can always use ribbons at the ankles if you wish, thenpress all pieces as per ball band instructions.

Please contact juliuscheeser63@sky.com if you have any problems. Copyright © Pattern, Images & Words Barefoot Baby

Bootique/Julie Findleton 2012. Please DO NOT reproduce this pattern