BMW ABS REMOVAL INSTRUCTIONS FORBMW 320 325 328 330 Z3---------------------------------------------------------------------------------------------------------BMW320 01 Assm, (Sed, Canadian mkt), w/Dynamic

Stability Cont (DSC)BM325I 01 Assm, exc Xi; w/Dynamic Stability Cont

(DSC)BMW330 01 Assm, exc Xi; w/Dynamic Stability Cont

(DSC)BMWZ3 01-02 Assm, 2.5L and 3.0L, w/Dynamic Stability

Cont (DSC)

ANDBMW320 01 Assm, (Sed, Canadian mkt), w/o Dynamic

Stability ContBMW323 99 Assm, Sed (E46), w/o Dynamic Stability ContBMW323 00 Assm, w/o Dynamic Stability ContBM325I 01 Assm, exc Xi; w/o Dynamic Stability ContBMW328 99 Assm, Sed (E46), w/o Dynamic Stability ContBMW328 00 Assm, w/o Dynamic Stability ContBMW330 01 Assm, exc Xi; w/o Dynamic Stability ContBMWZ3 99-00 Assm, 2.8L, w/o Dynamic Stability Cont

Assm, 2.5L, w/o Dynamic Stability ContBMWZ3 01-02 Assm, 2.5L and 3.0L, w/o Dynamic Stability

Cont

Before starting work, read out fault memory of ABS/DSC control module and printout diagnostic record if applicable ,This is suggested in case other Issues maybe relevant such as Wheel speed sensor failure ,CAN Communication Issues suchas Inlet Valve failure, In some Instances these failures can be cured do to internal ABSModule Damage.

Remove diagnosis socket from fixture and place to one side.Unfasten plug connection (2) and disconnect.Release screws (1) and carefully remove control module (3).Use a 5/32nd 6 point socket to remove 4 two inch screws

AUTO & TRUCK ELECTRONICS 1-866-983-6688 WWW.AUTOECU.COM