Upload
christina-caldwell
View
216
Download
0
Tags:
Embed Size (px)
Citation preview
Bench Tools + (Metalwork)
The 300mm rule is marked out in both Metric and Imperial sizes
Rule
The Rule is made from Stainless Steel
Metric Scale (mm)
Imperial Scale
(Inches)
Odd Leg Callipers are used to draw a line parallel to an edge
Odd Leg Callipers
A Scriber is used to mark out on metal
Scriber
An Engineers square was used to mark lines at right angles to an edge.
Engineers square
Each work station is equipped 4 files
1 Rough cut Rectangular File
1 Smooth cut Rectangular file
1 Half Round File
1 Round File
One edge of the file has no teeth. This is called the Safe Edge
Remember never use a file with a broken or missing handle.
Files
The part of the file inside the handle is called the Tang
The Centre punch and Ball Pein Hammer are used to mark the centres of holes before drilling
Centre Punch is made from high carbon steel
Ball Pein Hammer
Ball Pein Hammer
Centre Punch
Spring Dividers
Spring dividers are used to mark curves on metal.
To obtain the best results you should always Centre punch the middle of your curve before you try to use the dividers
The End