7
Belkin NetCam HD Speaker Replacement This guide will show you the steps in replacing the speaker in your Belkin NetCam HD+. Written By: Destinie DiazVerdejo Belkin NetCam HD Speaker Replacement © iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 7

Belkin NetCam HD Speaker Replacement - the-eye.euthe-eye.eu/public/Books/iFixIt Guides/Belkin NetCam HD Speaker...INTRODUCTION When you know your phone connection with the camera is

  • Upload
    others

  • View
    2

  • Download
    0

Embed Size (px)

Citation preview

Belkin NetCam HD Speaker ReplacementThis guide will show you the steps in replacing the speaker in your Belkin NetCam HD+.

Written By: Destinie DiazVerdejo

Belkin NetCam HD Speaker Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 7

INTRODUCTION

When you know your phone connection with the camera is good, but no sound is going through. Thespeaker could have gone out and needs to be replaced.

TOOLS:iFixit Opening Tools (1)

Phillips #0 Screwdriver (1)

Tweezers (1)

Adjustable Wrench (1)

Belkin NetCam HD Speaker Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 7

Step 1 — Case

Use a wrench to loosen up the standfrom the back in order to hold theNetCam more comfortably.

Step 2

Work a plastic opening tool into theseam and pry the face plate awayfrom the back panel.

Belkin NetCam HD Speaker Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 7

Step 3

Use pressure to separate the covers.

When pulling the device apart, separate from the bottom up in order to avoid pulling the wiring atthe top apart.

Step 4 — Front Casing

Carefully use your fingers to gentlypull out the white attachment fromthe tan colored part.

Belkin NetCam HD Speaker Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 7

Step 5 — Speaker

Use a Phillips #0 screwdriver to take out the two 1.2 mm screws on the board.

Step 6

With your fingers, pull the circuit board out of the back casing.

When pulling the board up be sure to do so carefully so you do not break the cord which isattached on the back side.

Belkin NetCam HD Speaker Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 7

To reassemble your device, follow these instructions in reverse order.

This document was last generated on 2017-06-18 07:21:51 AM.

Step 7

Gently pull the speaker out of the holder from the back of the cover.

Step 8

The speaker wires are attached withthe board. It can be unattachedgently by pulling out the whiteattachment from the port.

Belkin NetCam HD Speaker Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 7

Belkin NetCam HD Speaker Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 7 of 7