Upload
truongque
View
228
Download
0
Embed Size (px)
Citation preview
Eze -25
BMFC
Eze-25 Control-line stunt trainerDesigned by Keith Renecle for .25 to .30 engines
Original model flown with Enya SS30S
Inch scale
Cm. scale
00 11 22 33 44 55 66 77 88 99 1010
00 11 22 33 44 55 66 77 88 99 1010 11 1122 2233 3344 4455 5566 6677 7788 8899 992020 3030
Wingspan 45 inches
Rudder fin, stab, elevator are 3/16” Balsa woodThis plan shows half stab/elevator.
Elevator horn from 3 mm ply woodBush hole with 1/8” brass tubing.Glue small strips of 3/16” balsaon either side of horn on top of elevator to strengthen it
Cut out to fit elevator hornon right half of elevator, andsmall cut-out on stab
EZE-25 Root
EZE-25 Tip
Wing-tip rib1/8” balsa
3” Nylon bellcrankLead-out rake guide (1/16" ply)M3 x 15 boltThin tubing
or eyelets
Washer
Foam leading edge templates
Holes for nails
Width of foam block at the tip
Width of foam block at root
Make from 4 mm nylon
Rib TemplateRibs are 1/8” balsa
Landing gear from 1/8” Piano wire
Fuel tank made from tin platePipes are 1/8” (3 mm) brass or copper tubing
Fuel Tank
1/4” Balsa leading edgetrim and sand to shape
The length of the foam coreis 21 inches (533.4 mm)
For the ribs directly on the fuselage,cut here. Do this by placing the outer rib over the inner rib, and using it as a template.