2
Systems | ARD-P0834-01 - Proximity reader with keypad Functions Operation Modes The ARD-P0834-01 - equipped with 2 electronically interlocked devices: The Proximity Reader and the Piezoelectric Keypad. ARD-P0834-01 - HID supports the following operation modes: 1. Prox-Pin: Present Prox card. The unit will read the content and send it over the Data wires to the host. Enter PIN code. The unit will send each digit over the same Data wires to the host. The Keypad and the Prox reader are interlocked so that when one is functioning the other is inhibited until the data is transmitted. 2. Prox-only: The prox electronics is independently communicating via Data wires. Verification Power up the unit. During the first 2 seconds the unit will activate the buzzer and the Yellow LED 3 times. In the same time the RED or the Green LED will come ON depending on the Central Computer setup. Present a valid HID encrypted card at 5 cm distance maximum. The unit will activate the Buzzer and the Yellow LED once. Each key press will activate the Buzzer and flash the Red or Green LED (the one that active) . Wiegand Specification When the LED control input is pulled low, the GREEN LED will be ON and the RED LED will be OFF. When the input goes high the RED LED is ON and the GREEN LED is OFF. The RED or GREEN LED will flash with each key press. The LED control input is pulled to the internal +5v with a 2.2K resistor. The data is sent at 2 milliseconds per bit with a pulse duration of 70 μsec. A Buzzer beeps with each key press. Installation/Configuration Notes Preparing and Mounting Remove the backplate from the reader Fix the backplate at the wall Put the cable into the cable hole Fix the reader with 4 screws Fix the backplate with a screw Note Special screwdrivers are necessary. ARD-P0834-01 - Proximity reader with keypad Prox reader with keypad Piezoelectric keypad with 8 bit burst output Wiegand interface Rugged reader www.boschsecurity.com

ARD-P0834-01 - Proximity reader with keypad - Bosch …resource.boschsecurity.us/documents/Data_sheet_enUS_1411469707.pdfSystems | ARD-P0834-01 - Proximity reader with keypad Functions

Embed Size (px)

Citation preview

Page 1: ARD-P0834-01 - Proximity reader with keypad - Bosch …resource.boschsecurity.us/documents/Data_sheet_enUS_1411469707.pdfSystems | ARD-P0834-01 - Proximity reader with keypad Functions

Systems | ARD-P0834-01 - Proximity reader with keypad

Functions

Operation Modes

The ARD-P0834-01 - equipped with 2 electronicallyinterlocked devices: The Proximity Reader and thePiezoelectric Keypad.

ARD-P0834-01 - HID supports the following operationmodes:

1. Prox-Pin:Present Prox card. The unit will read the content andsend it over the Data wires to the host. Enter PIN code.The unit will send each digit over the same Data wiresto the host. The Keypad and the Prox reader areinterlocked so that when one is functioning the other isinhibited until the data is transmitted.

2. Prox-only: The prox electronics is independently communicatingvia Data wires.

Verification

Power up the unit. During the first 2 seconds the unit willactivate the buzzer and the Yellow LED 3 times. In the sametime the RED or the Green LED will come ON depending onthe Central Computer setup.

Present a valid HID encrypted card at 5 cm distancemaximum. The unit will activate the Buzzer and the YellowLED once.

Each key press will activate the Buzzer and flash the Red orGreen LED (the one that active) .

Wiegand Specification

When the LED control input is pulled low, the GREEN LEDwill be ON and the RED LED will be OFF. When the inputgoes high the RED LED is ON and the GREEN LED is OFF.The RED or GREEN LED will flash with each key press. TheLED control input is pulled to the internal +5v with a 2.2Kresistor.

The data is sent at 2 milliseconds per bit with a pulseduration of 70 μsec. A Buzzer beeps with each key press.

Installation/Configuration Notes

Preparing and Mounting

• Remove the backplate from the reader• Fix the backplate at the wall• Put the cable into the cable hole• Fix the reader with 4 screws• Fix the backplate with a screw

Note Special screwdrivers are necessary.

ARD-P0834-01 - Proximity reader withkeypad

▶ Prox reader with keypad

▶ Piezoelectric keypad with 8 bit burst output

▶ Wiegand interface

▶ Rugged reader

www.boschsecurity.com

Page 2: ARD-P0834-01 - Proximity reader with keypad - Bosch …resource.boschsecurity.us/documents/Data_sheet_enUS_1411469707.pdfSystems | ARD-P0834-01 - Proximity reader with keypad Functions

2 | ARD-P0834-01 - Proximity reader with keypad

Wiring

COLOR FUNCTION ELECTRICAL FUNCTION

RED Input Voltage 12 to 24 VDC

BLACK Ground

GREEN Data 0 Open collector 1KOhm pull-up to inter-nal +5V

WHITE Data 1 Open collector 1KOhm pull-up to inter-nal +5V

BROWN LED input No voltage

BLUE CCTV output Open collector 0,1 A activated witheach key for 30 sec.

VIOLET Housing ground

ORANGE Buffered input No voltage

GREY Tamper output Open collector 0,100 A “Low” whenlight sensed.

PIN data in 8 bit burst output format

Each key press generates the defined 8 bit output as shown:

KEY OUTPUT KEY OUTPUT

0 11110000 6 10010110

1 11100001 7 10000111

2 11010010 8 01111000

3 11000011 9 01101001

4 10110100 * 01011010

5 10100101 # 01001011

Technical Specifications

Output Formats:Prox. CardKeypad

-Wiegand 268 Bit Burst

The Prox. Card Output is customizable for other Wiegand formats.

Distance to access panel max. 158m

Power Supply 12 to 24 VDC

Power Consumption max. 150 mA

Transmitter/Receiver Frequency 125 Khz

Mounting Back box mounting or wall mounting

Environment IP68; 100% relative humidity

Operating Temperature -30 to +65 °C (-22 to 150 °F)

Dimensions 120 x 90 x 20 mm(4.72 / 3.54 / 0.79 in.)

Ordering Information

ARD-P0834-01 - Proximity reader withkeypadRugged reader (Prox – 125 KHz) with piezo-electric keypad, beeper and LED displays. Out-put formats: 26 Bit card and 8 Bit keypad

ARD-P0834-01

Americas:Bosch Security Systems, Inc.130 Perinton ParkwayFairport, New York, 14450, USAPhone: +1 800 289 0096Fax: +1 585 223 [email protected]

Europe, Middle East, Africa:Bosch Security Systems B.V.P.O. Box 800025600 JB Eindhoven, The NetherlandsPhone: + 31 40 2577 284Fax: +31 40 2577 [email protected]

Asia-Pacific:Robert Bosch (SEA) Pte Ltd, Security Systems11 Bishan Street 21Singapore 573943Phone: +65 6258 5511Fax: +65 6571 [email protected]

Represented by

© Bosch Security Systems Inc. 2010 | Data subject to change without noticeT3650358539 | Cur: en-US, V6, 4 Jul 2010