THERMOCOUSTICANTI-VIBRATIONS ACOUSTIC PANEL

FOR

BATHTUBSSPASWHIRLPOOL BATHSTHERAPEUTIC BATHSSHOWERS

THERMOCOUSTIC is a product composed of elastomeric bitumen and recycled tire pellets. Its surface, aluminum foil, offers radiating properties. Its underside is covered with an HDPE film providing enhanced mechanical properties. THERMOCOUSTIC is an excellent vapour barrier.

RESISTOSOUND SOUNDPROOFING PRODUCT LINE

A solution from

Soundproofing products

SURFACE PREPARATIONWOODMake sure the surface is free of all debris, such as nails, screws or any other construction rubbish that may damage the product once the floor finish is applied on the product.

Generally, a good cleaning is enough to prepare the surface. Also make also sure that there are no gaps between the two floor support panels. If necessary, fill those gaps with acoustic sealant.

CONCRETE The same preparation as for the wood deck should be performed, but since this product is a vapour barrier, you must also make sure that the concrete deck does not have a moisture rate so high that the product traps the moisture in the concrete.

A maximum moisture content of 3 lb/1,000 ft2/24 h (1.46 kg/100 m2/24 h) is recommended. This reading can also be taken with a calcium chloride test.

ADVANTAGES• Acoustic product permitting substantial noise reduction up to 21 dB (A) through vibration absorption

• Ecological product using recycled tires, without release of odours

• Reduces heat loss due to its highly reflective surface

• Energy efficient

• Excellent vapour barrier

• Light weight and easy to install

• Practical panel format facilitates handling

• Flexible, and easily upturned onto perimeter walls

• Used on wood or concrete substrates

• Rot-proof

• Ideal for condominiums

THERMOCOUSTICANTI-VIBRATIONS ACOUSTIC PANEL

INSTALLATION METHODTHERMOCOUSTIC is installed butt edge on the substrate without overlaping the pieces. The laps of the THERMOCOUSTIC are sealed with adhesive tape, preferably with an aluminum surface. THERMOCOUSTIC is flexible enough to be upturned 90° onto the perimeter walls.

Install THERMOCOUSTIC aluminum side up.

THERMOCOUSTICANTI-VIBRATIONS ACOUSTIC PANEL

PRODUCT CHARACTERISTICSNominal thickness: 4 mm (0.157 po)Dimensions: 902 × 1219 mm (35 ½ × 48 in)Nominal weight / panel: 3.17 Kg (7.0 lb)Mass per unit area: 2.80 Kg / m2 (0.58 lbs / ft2)Noise reduction*: Up to 21 dB (A)Packaging: The product is delivered in bulk on pallets.

* Test performed on a concrete slab 20 cm (8 in) thick without ceiling

AR

206_

0920

14

1.877.626.6688 1.877.478.8408www.resisto.ca

THERMOCOUSTICANTI-VIBRATIONS ACOUSTIC PANEL

PEACE OF MINDRELAXINGCOMFORTPEACEFUL HOME

WARRANTYRESISTOSOUND products are guaranteed against all manufacturing defects and to be suitable for all stated uses. SOPREMA's liability under this garantee is limited to replacing or refunding the purchase price of RESISTOSOUND products found to be defective.