Upload
vongoc
View
215
Download
1
Embed Size (px)
Citation preview
Application of Court Markings
and Logo’s on Indoor Synthetic
Sports Floors
•Poured-in-Place Urethane
•PVC Roll Goods
•Plastic Tiles
•Rubber Tiles & Roll Goods
Considerations
•Numerous textures
•Use a tape sealer
•Type of tape
•Type of paint
•Light paint coats
•Spray paint coats
•Crisp lines vs. fussy lines
Poured-in-Place Urethane
Todd Goodridge
Technical Services Manager
Robbins Sports Surfaces
Poured-in-Place Urethane
Game lines & logo’s are painted of the surface with 2
component urethane paint
Poured in place urethane
- painted game lines &graphics
Poured in place urethane
- painted court markings
Tape off all lines, double roll
Don’t forget to Pencil tape over lap
Use a standard tape line machine
Tape off lines, double roll
Preferred tape
3m Long Mask
3M 233+
Q&A
Any questions?
Todd Goodridge
Technical Service Manager
Robbins Sports Surfaces
BRUCE HAROLDSON
CONNOR SPORTS FLOORING
Sheet Vinyl & Plastic tile
r
•PAINT/PRIME
•MOST VINYL IS PAINTED WITH TWO-
PART POLYURETHANE PAINT
•SOME PAINT/VINYL REQUIRES A
PRIMER
•USE RECOMMENDED MASKING TAPE
PAINT/PRIMER
MOST VINYL IS PAINTED WITH TWO-PART
POLYURETHANE PAINT
SOME PAINT/VINYL REQUIRES A PRIMER
USE RECOMMENDED MASKING TAPE
AFTER LAYOUT DONE – MASKING TAPE APPLIED
GAME LINES PAINTED
AFTER PAINTING COMPLETED – TAPE IS PULLED
.
LOGO MASK APPLIED
LOGO PAINTED
MASK REMOVED AFTER
PAINTING COMPLETED
.
LETTERS OUTLINED BY MASK
LETTERS PAINTED
MASK PULLED AFTER PAINTING
PAINTED KEYS
SURFACE ABRADED – PRIMER IF REQUIRED
Completed Job
Completed Job
Q&A
Any questions?
BRUCE HAROLDSON CONNOR SPORTS FLOORING
Roll rubber goods & rubber tiles
Erika Marcoux Technical Department Supervisor
Mondo America, Inc.
Rubber goods
Custom Logos
Possible on any rubber flooring product of any thickness
Can be painted on the rubber flooring
Can be inlaid into the rubber flooring
Painted Logos
This method is infrequent
Installer must be well experienced in painting rubber surfaces and logo design/applications (use of stencil)
Rubber surface must be prepared to receive painted logo; see Manufacturer for details
Generally requires a form of chemical and/or mechanical preparation, as well as the application of a primer
Inlaid Logos
This method is commonly used
Installer must be well experienced in the installation of rubber flooring and inlaid logos
Possible by freehand cutting, but rubber flooring is typically waterjet cut into the desired logo
Be mindful of tolerances when using multiple colors, textures, etc.
Application Method Comparison
PAINTED
Custom paint colors may be available; see Manufacturer
Requires on-site preparation; longer application time
Stencil fragility/less details
Human error/lack of precision/paint bleeding
Corrections may be very difficult
INLAID
Custom flooring colors may be available; see Manufacturer
Pieces are delivered ready to install
Installs over same base requirements
Design details/ waterjet precision
Corrections and updates can easily be made; simply replace area
Custom Inlayed Graphics in
Rubber Goods
Hand Cut
Water Jet Cut
Hand Cut
Logos
.
Q&A
Any questions?
Erika Marcoux Technical Department Supervisor
Mondo America, Inc.