Ammunition Overview

CW2 John M. Lloyd

Supply Management Officer

AGCW

Objectives

Introduction to the Centralized Ammunition Management (CAM)

Affects on Training Operational Ammunition requests CADS/PADS Ammunition Issues Ammunition Turn-ins CAT I

Centralized Ammunition Management

Joint Munitions Command (JMC) Manages wholesale and retail ammunition

stocks as a unified whole. Allow JMC to manage ammunition at ASP’s

until issued to units for training or operational load.

Reduces transportation costs. Provides better distribution management. Provides JMC with total asset visibility.

Procedures Prior to CAM

ASP inventory based on historical usage data Mass-based Logistics Concept-Stock Pile USPFO Stock Control managed inventory

levels. Visibility through DA Form 581 Utilized AEPS requisition procedures

JointJointMunitionsMunitionsCommandCommand

StateStateTraining AmmoTraining Ammo

ManagerManagerTrainingTraining

ForecastsForecastsTAMIS-RTAMIS-R

StockStockOn HandOn Hand

SAAS-MODSAAS-MOD

Ammo Supply Point

ConsolidatedResupply

Centralized Ammunition ManagementCentralized Ammunition ManagementConcept of OperationsConcept of Operations

Basic LoadBasic LoadRequirementsRequirements

(ABLCS/DAART)(ABLCS/DAART)

DetermineDelta/

Optimize Inventory

Pick up Ammo

EnhanceEnhance strategic mobility/deployability strategic mobility/deployability ReduceReduce sustainment footprint sustainment footprint

ReduceReduce cost of logistics while maintaining cost of logistics while maintaining warfighting capability and readinesswarfighting capability and readiness

MACOMMACOMTraining &Training &

Deployment Deployment RequirementsRequirements

CSA LTTF INITIATIVECSA LTTF INITIATIVE

Long Term BenefitsLong Term Benefits Readiness CostReadiness Cost

Regional DefenseMunitions Center

Procedures under CAM

Ammunition needs are visible through TAMIS-R.

Requirements are based on Calculator JMC sends ASP monthly CAM Study ASP reviews CAM Study, makes adjustments ASP receives 90 day inventory Push based

on forecasted requirements ASP required to ship excess ammunition

worldwide.

CAM Calculations

Calculator Utilizing data, shortage calculated using following

formula: Due-ins + Assets – 90-day forecast = Plus or

Minus (shortage) Determines the CAM PUSH ASP Reviews CAM Study monthly makes

adjustments for NEW Storage, RDD, CAT I, CAT II to Tooele.

Calculator sorts by CALS and Non-CALS Applies data from Overhead Fire Table Generates RDD (6 weeks from 1st working day of month)

How does CAM affect training?

CAM push is determined through TAMIS-R forecasts.

Inventory based on projected requirements. CAM directs excess to where there is a

requirement. Reduces flexibility for Ammunition based

training. Training and Operational Load ammunition

must be forecasted.

Training vs. Operational Ammo TRAINING Forecast in TAMIS-R Submit TAR TEC = TRS * 90 DAY FORECAST WINDOW

TRAINING No Forecast in TAMIS-R Memo to NGB Submit TAR Ordered in the CAM Study

OPERATIONAL LOAD Ammo likely to be Expended TEC = OPL Memo to NGB Submit a TAR Ordered in the CAM Study

Ammo not likely to Expend TEC = OPN Memo to NGB Submit a TAR Ordered in the CAM Study

OP Load AMMO must be CC A OP Load Ammo in PBIC #8-

Property Book

AVIATION AMMUNITION

CADS/PADS TEC = OPL Submit a TAR Stock Control will

request in AEPS (AOE)

CADS/PADS, installed

or uninstalled, must be

accounted for on the

property book in PBIC #8.

L119-ALSE TEC = OPN Submit a TAR Ordered in the CAM

Study

CADS/PADS

Request CADS/PADS DA Form 581 (TAR) Include Tail # in

remarks column 1-1 Exchange at ASP

Turn in CADS/PADS CADS/PADS

Submission Spreadsheet

DA Form 581 T/I T/I in CC K Appointment with ASP ASP request

disposition from Rock Island.

CADS/PADS SUBMISSION

TAIL #ARCFT MODEL

#NSN DODIC NOMENCLATURE LOT # QTY INST DT RMV DT

Effective Ammo Draws

Forecast in TAMIS-R IAW UTARNG 350-1.

Submit TAR IAW UTARNG 350-1.

Review ASP SOP for Coordination times with Stock Control and ASP.

Request for realistic training requirements.

TIPS: DA Form 1687 Current Haz-Mat Certification on

Mil Drivers License-348 DD 626 Convoy Clearance Vehicle requirements. TAMIS-R Pick up

times-Call ASP Refer to AGCW web site

for Ammunition tools.

.

Effective Ammo Turn-in

Turn-in required five (5) days from the Training Event.

DA Form 581’s must be completed prior to the Turn-in.

Units required to provide enough personnel to accomplish the turn-in task.

Turn in tasks include: Unloading Segregating by DODIC

and lot number Inspecting Repacking Re-stenciling

Containers Place in bunkers Both Live and Residue

CAT I Ammunition

Requires unit pick up at TEAD. Must have an armed escort. Store in FASP in approved containers. Requires two man rule for access. 24 hour armed guard surveillance. Category I

“Non-nuclear man portable missiles and rockets “in a ready to fire” configuration”

AT4, Stinger, Dragon, LAW, Viper, etc.

Questions?