Installation Procedure Design Entry HDL

Allegro Starter Library Installation Guide

Design Endtry HDL InstallationAllegro Design Workbench InstallationAllegro Design Entry CISInstallation Procedure Design Entry HDL

Extract Cadence_Starter_Library.zip file onto your C: or D: Drive

it will automatically create a folder called 'Cadence_Starter_Library'

1, Create a new Desing Project with Allegro Project Manager

2, Once created click on the SETUP radio button

3, Click EDIT next to the CDS.LIB

Add the additional new line below:

INCLUDE C:/Cadence_Starter_Library/DesignEntryHDL/DEHDL_Library/cds.lib

4, Close the cds.lib text file click APPLY

5, Add All Available Libraries to your Project Libraries area

6, Click OK

7, Create an Allegro ENV file in your $HOME\pcbenv folder with the following entries:

source $TELENV

### User Preferences section

### This section is computer generated.

### Please do not modify to the end of the file.

### Place your hand edits above this section.

###

set psmpath = $psmpath C:\Cadence_Starter_Library\DesignEntryHDL\Allegro_Symbols\flashes\ C:\Cadence_Starter_Library\DesignEntryHDL\Allegro_Symbols\footprints\

set padpath = $padpath C:\Cadence_Starter_Library\DesignEntryHDL\Allegro_Symbols\padstacks\

Installation Procedure Allegro Design Workbench

Extract Cadence_Starter_Library.zip file onto your C: or D: Drive

it will automatically create a folder called 'Cadence_Starter_Library'

ADW_Library_Import setup procedure is documented in:

Cadence_Starter_Library\Documentation "ADW Starter Library Import Guide.doc"

Installation Procedure Design Entry CIS

Extract Cadence_Starter_Library.zip file onto your C: or D: Drive

it will automatically create a folder called 'Cadence_Starter_Library'

Design Entry CIS setup procedure is documented in:

Cadence_Starter_Library\Documentation "DesignEntryCIS_Setup Readme.doc"

In this document change to the path to where you extracted

the zip file

Example:

* Note we assume you installed the Cadence Starter Library ZIP file into the C: drive.

DIR0=\datasheets

DIR0=C:\Cadence_Starter_Library\DesignEntryCIS\Datasheets

Create an Allegro ENV file in your $HOME\pcbenv folder with the following entries:

source $TELENV

### User Preferences section

### This section is computer generated.

### Please do not modify to the end of the file.

### Place your hand edits above this section.

###

set psmpath = $psmpath C:\Cadence_Starter_Library\DesignEntryCIS\PCB_Symbols\flashes\ C:\Cadence_Starter_Library\DesignEntryCIS\PCB_Symbols\footprints\

set padpath = $padpath C:\Cadence_Starter_Library\DesignEntryCIS\PCB_Symbols\padstacks\