Upload
ok2spray
View
220
Download
2
Embed Size (px)
DESCRIPTION
Adhesive Remover, Super Strength Adhesive Remover, Non-Flammable High Strength Spray Adhesive, Glue for Composites, Aerosol Adhesives, Multi-Purpose HighTack Spray Adhesive, High Strength Fine Spray Adhesive
Citation preview
Precautions to be taken while Using Adhesive Removers
http://www.ok2spray.com/wt-ccar.php
The use of most of the adhesive removers should be done with extreme
precaution and care. The safety instructions and warnings displayed by the
manufacturer on its packing or the product pamphlet must be read and
understood properly. Prior to opening the container and its use,ensure the
shelf life of the product, which is usually 24 months at the recommended
conditions of storage in original and unopened containers.
Careful Handling
Most of these products are highly inflammable and are harmful and may
cause damage to the lungs of the user, if inhaled. Care should be taken to
not breathe in the vapors. Smoking should be strictly prohibited at the area
of its use and it should be away from any ignition sources to avoid mishaps
of fire.
It is recommended to wear suitable gloves while using them. Preferably use
them in properly ventilated areas and if that is impossible use adequate
respiratory equipment for safety.
Safety Measures after Health Mishaps
These materials can cause damage to the eyes if it comes in contact with the
eyes of the worker who uses it. If it happens, eyes should be washed with
plenty of water and the victim should be immediately taken to a doctor for
proper treatment. The label or the container should be shown to the doctor
so that he has knowledge of the chemical composition of the product which
is the cause of the problem.
There is more than a likely chance for these to come in contact with the skin
of the worker who is using it and in such a case the material should be
wiped off the skin as cleanly as possible and washed immediately with lot of
soap and water.
Use of Adhesive Removers
Adhesive removers with citrus cleaner has a fresh citrus scent and can
remove adhesive and scars, graffiti, scuff marks etc. from a variety of
surfaces. They are mostly used in metals, flooring, printing equipment,
concrete etc. These are also used for cleaning heavy oils, greases, tar etc.
which are difficult to clean off from a surface. These are useful for thorough
cleaning of the surface of any area prior to painting, coating or even for
bonding of different parts. Good quality products in this category evaporate
cleanly leaving minimal residue at its area of application and a mild citrus
scent.
Application
Care should be taken while the process of removing the adhesive from the
surface which has to be cleaned. Firstly, spray the remover generously onto
the surface to be treated. Allow it to act on the adhesive for a couple of
minutes. Note the time required for the remover to work from the manual of
the product as this depend on the glue type.
If required, regularly moisten the glue with the spray. Now use a proper
scraper to remove the adhesive which is stuck on the surface.Just be careful
to see that no scratches are made on the surface. Repeat the process if the
surface does not get properly cleaned.
Precautions to be Taken
Most of these products come with a Material Safety Datasheet with health
and safety information which should be read and understood before using
the product. Keep the products in safe and sealed containers. Care should
be taken while disposal of these hazardous products and it should be done
as per the local waste regulations. It may be left to evaporate in a controlled
space with no ignition sources nearby or incinerated in an approved facility.
If a number of wipes have been used for the work, keep all the wipes in a
sealed container prior to its disposal. Used wipes should be disposed off as
per safety regulations followed by waste requirements of local authorities.
For more information : http://www.ok2spray.com