Upload
vuongdang
View
278
Download
9
Embed Size (px)
Citation preview
12/4/2010
1
AC to DC Converter (Rectifier)AC to DC Converter (Rectifier)
ASNILELEKTRO FT - UNP
12/4/2010
2
Penyerah tiga fasa tak terkendaliTiga fasa setengah gelombang
Penyearah tiga fasa setengah gelombangPenyearah tiga fasa setengah gelombang
12/4/2010
3
Proses penyearahan :
Selama polaritas + dari V1 (dari 0-π): dioda D3 lebih dahulu ONkarena V3 lebih + dari V1 (dari 0-
/6) l j t l i /6 5 /6π/6), selanjutnya mulai π/6-5π/6dioda D1 ON, tetapi karena V2lebih + dari V1 saat 5π/6-π makaD2 ON, dan seterusnya.
12/4/2010
4
the average value of the output can be found as
the rms value of the output voltage can be found as
the rms current in each transformer secondary winding can also be found as
12/4/2010
5
Penyearah gelombang-penuh Tiga Fasa
Proses penyearahan :• D1, D3, dan D5 akan ON jika anoda terhubung dengan tegangan fasa tertinggi saat itu.• Da, D4, atau D6 akan ON jika katoda terhubung dengan tegangan fasa terendah saat itu.• D1 dan D4, D3 dan D6, D2 dan D5 tidak boleh ON secara bersamaan.• Tegangan luaran pada beban dihasilkan dari tegangan line sumber.• Dioda ON secara berpasangan (6,1), (1,2), (2,3), (3,4), (4,5), (5,6), (6,1),…. Jadi, dioda ONdengan urutan 1,2,3,4,5,6,1, …
12/4/2010
6
12/4/2010
7
Tegangan keluaran rata-rata Tegangan keluaran rms adalah
Arus rms pada sekunder trafo Arus puncak yang melalui dioda
Arus rms yang melalui dioda
Im adalah arus puncak line sekunder
Vm adalah tegangan fase puncak
12/4/2010
8
AC – DC controlled Rectifier
Si l Ph H lf W R tifiSingle-Phase Half-Wave Rectifier
Single thyristor rectifier with resistive load.
12/4/2010
9
The load average voltage is given by:
Vm : puncak tegangan masukan
12/4/2010
10
Gate Signal Generation
12/4/2010
11
Single thyristor rectifier with: (a) resistive-inductive load; and (b) active load.
12/4/2010
12
When the thyristor is turned ON, the voltage across the inductance isRectifier for an R - L load.
The voltage in the resistance R is
The load current is
Rashid, 169
Rectifier for inductive-active load
12/4/2010
13
The load is fed via a thyristor in each positive cycle of voltages v1 and v2
d th l d t t i th
Single-Phase Controlled Rectifier
and the load current returns via the neutral N.With reference in picture bisaides, thyristor T1 can be fired into the ON state at any time provided that voltage vT1 > 0. The firing pulses are delayedvT1 0. The firing pulses are delayed by an angle a with respect to the instant where diodes would conduct. In be next waveform also illustrates the current paths for each conduction state. Thyristor T1 remains in the ON state
til th l d t t i t tuntil the load current tries to go to a negative value. Thyristor T2 is fired into the ON state when vT2 > 0, which corresponds in picture below to the condition at which v2 > 0.
12/4/2010
14
12/4/2010
15
The load voltage with resistive load is
Tegangan luaran (output) efektif, Vo,rms dan Arus luaran efektif, Io,rms :
⎥⎦⎤
⎢⎣⎡ +−
==πα
παπ
42sin
2
2/1
, mrmsrmso VEV
12/4/2010
16
AnalisisAnalisis RangkaianRangkaian dengandengan bebanbeban induktifinduktif (RL)(RL)
αcos2 mVV = απ
cos,DCoV =
Jika dipasang DIODE KOMUTASI yang dihubungkan paralel dengan beban RL, maka:
( )απ
cos1, +== mdcDCo
VEV
12/4/2010
17
Single-Phase Controlled Rectifier
Single-phase bridge rectifier: (a) fully controlled; and (b) h lf ll d(b) half controlled.
12/4/2010
18
This picture shows the voltage and current waveforms of the fully controlled bridge rectifier for a resistive load. Thyristors T1 and T2 must be fired simultaneously yduring the positive half wave of the source voltage vs so as to allow conduction of current. Alternatively, thyristors T3 and T4 must be fired simultaneously during the negative half wave ofduring the negative half wave of the source voltage. To ensure simultaneous firing, thyristors T1 and T2 use the same firing signal. The load voltage is similar to the voltage obtained with the biphase
Waveforms of a fully controlled bridge rectifier with resistive load.
half-wave rectifier.The input current is given by
12/4/2010
19
Waveforms of a fully controlled bridge rectifier with resistive-inductive load
12/4/2010
20
The high-load inductance generates a perfectly filtered currentand the rectifier behaves like a current source. With continuousload current, thyristors T1 and T2 remain in the on-state beyond the positive half-wave of the source voltage vs . For this reason, p g s ,the load voltage vd can have a negative instantaneous value. The firing of thyristors T3 and T4 has two effects:i) they turn off thyristors T1 and T2; andii) after the commutation they conduct the load current.This is the main reason why this type of converter is called a‘‘naturally commutated’’ or ‘‘line commutated’’ rectifier. Thesupply current is has the square waveform for continuous conduction.
12/4/2010
21
half controlled with high inductive load
Full controlled with R-L Load (high inductive load)(high inductive load)
Full wave controlled with R Load
12/4/2010
22
Three-Phase Half-Wave Rectifier
Three-phase half-wave rectifieThree-phase half-wave rectifie
12/4/2010
23
12/4/2010
24
High Inductive load
If
Resistive load and
12/4/2010
25
the load average voltage is
12/4/2010
26
DC current waveforms with resistive load
12/4/2010
27
AC current waveforms for the half-wave rectifier
12/4/2010
28
The current waveforms shown above are useful for designing the t f St ti fpower transformer. Starting from
12/4/2010
29
Then, to establish a relation between ac and dc voltages for
where a is the secondary to primary turn relation of the transformer On the other hand a relation between the currents istransformer. On the other hand, a relation between the currents is also obtainable.
and
12/4/2010
30
The meaning of above equation is that the power transformer has to be oversized 21% at the primary side, and 48% at the secondary side. Then, a special transformer has to be built for this rectifier. In terms of average VA, the transformer needs to be 35% larger that the rating of the dc load. The larger rating of the secondary respect to primary is because the secondary carries a dc component inside the windings. seco d y c es dc co po e s de e w d gs.Besides, the transformer is oversized because the circulation of current harmonics, which do not generate active power. The core saturation, due to the dc components inside the secondary windings, also needs to be taken in account for iron oversizingiron oversizing.
12/4/2010
31
Three-Phase Half Control Rectifier
12/4/2010
32
12/4/2010
33
12/4/2010
34
12/4/2010
35
Three-Phase fully Control Rectifier
Three-phase full-wave rectifier
12/4/2010
36
12/4/2010
37
12/4/2010
38
The load average voltage is given by:
12/4/2010
39
12/4/2010
40
Latihan
12/4/2010
41
Tugas dikumpul minggu depan lihat diTugas dikumpul minggu depan lihat dihttp://elektroftunp.wordpress.com
“Task Collection”
WassalamWassalam