8/12/2019 abb plug-in

1/8

8/12/2019 abb plug-in

2/8

8/12/2019 abb plug-in

3/8

8/12/2019 abb plug-in

4/8

8/12/2019 abb plug-in

5/8

8/12/2019 abb plug-in

6/8

8/12/2019 abb plug-in

7/8

8/12/2019 abb plug-in

8/8

The plug is designed so that its metalpart is earthed with a stainless

steel earthing spring. The earth caneasily be disconnected with a rod

prior to measuring, and then easily

connected again.Fulfils the requirements of CENELEC

HD 628/629.

New SWA plug-in cable connectorsuitable for ABB switchgearAX1, 12-24 kV

Cable accessories formedium voltage 12 24 kV

Description:

ABB's AXI switchgear has connection points foruse with plug-in connectors on thick cables. Theconnectors can be used with cables with alumi-nium or copper conductors, with cross-sectionsof 500 - 1200 mm2, and voltages of 12 and 24kV.

Stress grading is via a stress cone. Power trans-mission to switchgear is via a contact device withcontact springs of proven ABB standard. Thecontact device is to be screwed to the conduc-tor. Once the termination has been prepared, itis easily pressed into posi tion. An ingenious lock-ing device ensures that it stays in place. An alu-minium sleeve housing ensures complete per-sonal safety against accidental contact. The com-pact design of the SWAenables four parallel ca-bles to be connected.

Selected features: Stress grading of proven standard Automatic locking device keeps connector in

place Conventional cable preparation Simple installation No need for special tools

SWA meets the requirements of:

CENELEC:- HD628.1 S1- HD629.1 S1

ABB KabeldonABB Kabeldon

DesignationCross-sectionVoltage XLPE Co nductor Sheath Conductordiameter diameter diameter material

mm2 kV mm mm mmSWA/Al 500-1200