Upload
phamthuan
View
219
Download
0
Embed Size (px)
Citation preview
National coverage, local care
www.glugglugglug.comMains fed water solutions for your workplace
Telephone 01934 631 666
AA1 & AA2 Water Cooler
An ultra modern design that is stylish, affordable and reliable. Built using superior technology with hygiene and functionality in mind.
Features
• Hygiene Guard protects thedispensing point
• Remote dispensing push buttonsbuilt using dependable technology
• Optional self sanitising technology
• Integral dual cup dispenser
• Optional energy saving features –saving up to 46%
• Drip tray drain to waste ready
• Generous dispensing area forbottles
• Internal storage for filters
• Customisable branding panel
• Mains fed.
Alpha:
• Floor standing or countertop.Ambient and cold or hot and cold.Available in Silver finish.
Delta:
• Floor standing or countertop.Ambient and cold or hot and cold.Available in Polar White finish.
AA1/AA2 Water Cooler
remote dispensing mechanical
push buttons for better hygiene
available in Silver or
Polar White finish
GGG_AA1_AA2_160915
National coverage, local care
www.glugglugglug.comMains fed water solutions for your workplace
Telephone 01934 631 666
Installation requirements
• Mains fed water supply
• 240 V Electrical socket
installation
Cooling system
Stainless steel 3 litre cold water tank. Thermostatically controlled to 4-12˚C
Heating system
Stainless steel 2 litre tank. Thermostatically controlled to between 87-92˚C.
Designed to prevent total drainage for heating element protection. Easily accessible hot water tank drain at the back of the cooler.
Refrigeration
Quiet, air cooled static-type condenser. No fan required. Protected against motor overload. Unit hermetically sealed. R-134a refrigerant.
Power supply
220 V, 50/60 Hz.
Dimensions
Floor standing:
Height: 1122mm
Width: 299mm
Depth: 381mm
Countertop:
Height: 445mm
Width: 299mm
Depth: 411mm
Weight
Floor standing:
18.6kg
Countertop:
13.5kg
specifications
AA1/AA2 Water Cooler
Integrated dual cup dispenser (typical capacity of 100 cups in total).
Internal compartment for optional accessories such as filters and self sanitising ozone generators.
GGG_AA1_AA2_160915
To ensure quick and smooth installation in your proposed location, each machine will require a 13 amp (240 V AC) switched socket which should not be more than one metre from the machine. Each plumbed-in water machine needs to be supplied with water from a rising main. Machines cannot be connected to a storage tank water supply. The pipework should ideally be no more than one metre from the machine although our fully qualified engineers are able to install machines in the majority of locations. Pipework must be terminated with a 15mm BS1010 stopcock.
installation is quick and simple
and only carried out by professional Glug Glug Glug
engineers, qualified to EDWCA standards