8/13/2019 A223-041-16-47-SP-03
1/4
JOB SPECIFICATION FOR
FIRST AID HOSE REELJOB SPECIFICATION No.
A223-041-16-47-SP-03Rev. 1
Page 1 of 4
1 14.02.12 ISSUED WITH TENDER BBS AR AA
0 02.12.11 ISSUED WITH DRAFT TENDER BBS AR AA
Rev.
NoDate Purpose Prepared by Checked by Approved by
Format No. 8-00-0001-F1 Rev. 0Copyright EIL All rights
reserved
JOB SPECIFICATIONFOR
FIRST AID HOSE REEL
PROJECT: PDA UNIT REVAMP, MUMBAI REFINERY, HPCL.
CLIENT : M/S HPCL
8/13/2019 A223-041-16-47-SP-03
4/4
JOB SPECIFICATION
FORFIRST AID HOSE REEL
JOB SPECIFICATIONNo.
A223-041-16-47-SP-03Rev. 1
Page 4 of 4
Format No. 8-00-0001-F1 Rev. 0Copyright EIL All rights
reserved
1.0 SCOPE
This specification covers the requirements regarding material,
constructional detailsand test for Floor/Wall mounted First Aid
Hose Reel, intended for installation inbuildings as emergency fire
fighting equipment.
2.0 CODES AND STANDARDS
IS : 884 First-Aid hose reel for fire-fighting.
NOTE: - Latest Edition of IS shall be followed.
3.0 MATERIAL, CONSTRUCTION AND TEST
Material, Construction, tests and all other requirements shall
conform to IS: 884,Type-A Hose Reel, except as mentioned in the
Data Sheet of Hose Reel attachedwith Bids / Requisition.
4.0 SIZETwo braided rubber hose of 25mm NB of 30-mtr-length
conforming to of IS 444 Type-II and bearing the IS mark. Working
pressure shall not less than 10 Kg/cm2. Hosereel shall be fitted
with Gun Metal triple purpose nozzle. The reel shall be mounted
onexisting structures with suitable drum type arrangement and it
should be suitable foruse in seawater. The hose reel should be
painted fire red.
5.0 HYDRAULIC PERFORMANCE
First Aid hose reel shall be capable of discharging 24 lpm. The
horizontal range ofwater jet shall not be less than 6.0 m at inlet
pressure of 7 kg/cm2g.
6.0 MARKING
Each hose reel shall be clearly and permanently marked with the
followinginformation along with Purchaser's name.
a) Manufacturer's name or Trade Markb) Year of Manufacturec) The
letters IS: 884d) Length and size of tube carried on hose reel.e)
Type of Reel.
7.0 INSPECTION AND TESTING
Owner's / EIL's authorised representative shall have access at
all reasonable times to
vendor's works where Hose Reels are being manufactured and/or
tested. Vendorshall arrange for all tests and inspection facilities
for checking material, design andconstruction, hydraulic
performance, workmanship, finish and hydrostatic testing.
Anyshortcoming pointed out shall be rectified to the satisfaction
of the inspectors. Allconsumables i.e. water etc. shall be arranged
by vendor at his own cost.
8.0 VENDORs D RAWING AND DATA REQUIREMENT
Vendor shall furnish drawings and data as per "Vendor's drawings
and DataRequirements" for information and records.
