A2 POSTER PN4105 CONOR JACKMAN

09008191

This is a Massey Ferguson 50 B, while at home looking at this loader I thought why not make a loader on the bike based on this.

This is a Honda ATC 185. While at home looking at this I thought why not build a trike? It will add stability for the loader and look quite different too.

I am using the standard frame as I have researched many frames and began to design them to realise there was only small differences in the designs.

The mud guard will be difficult to produce as they are multi directional curved. This if possible will be made on the modelling machine

I am using the standard column mounting expect it will be wider to accommodate a wider front wheel.

The bucket will be a simple flat sheet rolled bucket with flat steel welded on for sides.

The tank will be based on the Honda’s trike tank depending on time the tanks complexity will increase or decrease