Embed Size (px)
Citation preview
INSTALLATION INSTRUCTIONS FOR PART 95-9306
95-9306B
APPLICATIONSBMW 3-Series 2006-10
(Use 98-9306 For Models With Heated Seats)
KIT FEATURES
• Double DIN Head Unit Provision• ISO Stacked Head Unit Provision• Painted matte black
• A) Double DIN Trim Plate • B) Double DIN Brackets • C) Two 1/2” #8 Pan Head Screws• D) Two Plastic Snaps
KIT COMPONENTS
1-800-221-0932 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
www.metraonline.com
D
C
TOOLS REQUIRED:Small Flat Blade Screwdriver/ Panel Removal Tool
Phillips Screwdriver • Torx Screwdriver • Cutting tool or file
A
B
Dash Disassembly- BMW 3-Series 2006-10(Non factory NAV) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Kit Assembly- Kit PreparationDouble DIN Head Unit Provision/ Stacked ISO DIN Head Unit Provision . . 3
TABLE OF CONTENTS
95-9306B
Note:Refer also to the instructions included with the aftermarket radio.
KNOWLEDGE IS POWEREnhance your installation and fabrication skills byenrolling in the most recognized and respectedmobile electronics school in our industry.Log onto www.installerinstitute.com or call800-354-6782 for more information and take stepstoward a better tomorrow.
Metra recommends MECP certifiedtechnicians.
1
3
4
BMW 3-Series 2006-10(NON FACTORY NAV)
95-9306B DASH DISASSEMBLY
Disconnect the negative battery terminalto prevent an accidental short circuit.
1
Carefully unclip and remove the climate controls. (Figure A)
Remove two Phillips screws fromthe bottom of the radio and remove.(Figure B)
Remove the four Torx screws fromthe sub-dash bracket and remove.(Figure C)
Continued on page 2.
2
C
A
B
2
95-9306B DASH DISASSEMBLY
Continue to kit assembly
Remove the climate control from theclimate control bezel. (Figure D)
5
Cut or file the edges of the climatecontrols as shown. (Figure E, F)
6
BMW 3-Series 2006-10(NON FACTORY NAV)
D
E
F
3
95-9306B KIT ASSEMBLY
KIT ASSEMBLY
1
2
Mount the DDIN radio to the suppliedDDIN brackets using ISO screws supplied with the aftermarket radio.
Locate the factory wiring harness inthe dash. Metra recommends usingthe proper mating adapters fromMetra and Axxess to intergrate yournew radio. Re-connect the negativeterminal and test the unit for properoperation.
3 Mount the radio into the dash. (Figure A)
Place the climate controls into theopening below the new radio andpush it back as far as it will go, with-out damaging the dash. (Figure B)
4
Push the included snaps onto thelegs on the top of the DDIN trim plate.
5
Clip the two included plastic snapsonto the top legs of the DDIN trimplate. Snap the DDIN trim plate overthe radio and use the supplied 1/2”screws to screw into the dash at thebottom. (Figure C)
6
C
B
A
95-9306B INSTRUCTIONS
NOTES
95-9306B INSTRUCTIONS
NOTES
06INSTRUCTIONS
1-800-221-0932
REV. 8/9/10 © COPYRIGHT 2003-2009 METRA ELECTRONICS CORPORATION INST95-9306B
www.metraonline.com
95-9306B INSTRUCTIONS
NOTES
