Upload
strato-varius
View
110
Download
13
Embed Size (px)
Citation preview
Cable Handling and Installation Phương pháp lắp đặt và nâng hạ cáp
Cable Handling and Installation | 37
Seal the cable always. Keep the cable from MoistureLuôn bịt đầu cáp để tránh ẩm ướt
Before Pulling release cable inner-end freely. Remove steel cover, rope and nails near Exit if any. Re-secure inner-end during pulling at time. The more pull, the more cable comes out.
Keep drums up-right; Don’t lay drum fat on their �angesĐể lô đứng, không đặt nằm lô
Use forklift or crane to load/unload cable drumsDùng xe nâng hoặc cẩu để nâng hạ lô cáp
Don’t drop cable drum from any heightKhông để lô bị rơi
Roll drums to arrow drectionLăn lô theo chiều mũi tên
VINA Cable & System
VINA Cable & System
VINA Cable & System
VINA Cable & System
VINA Cable & System
Arrow is not pulling directionKhông quay ngược chiều
Secure drum �rmly to prevent from rollingThắt chặt để tránh lô bị lăn
Be careful ! Nails on cover can harm your body and/or cableCẩn thận với đinh trên Lô để tránh bị thương hay hỏng cáp
Ghi chú: Không đúng cách
INSTRUCTIONS FOR DRUM HANDLING
INSTRUCTIONS FOR CABLE FEED IN
Hướng dẫn vận chuyển lô
Chú ý khi ra dây
Trước khi kéo cáp tháo bỏ tấm thép và đinh, kiểm tra lại an toàn trong suốt quá trình kéo
VINA Cable & SystemVINA Cable & System
VINA Cable & System
VINA Cable & System
VINA Cable & System
VINA Cable & System