Upload
chad-quella
View
3
Download
0
Embed Size (px)
Citation preview
FE-BE Bracket Repair Kit For 82/70, 82/90, 82/90XL, 8800 Gold and 90XLi Series Pinspotters
610 902 026
QAMF Document #
610 902 026P 3 1 2 5 6 4
Packing List
Item Qty Part No. Description
1 2 070 002 179 Repair Bracket, FE-BE
2 6 809 865 165 HHCS 3/8-16 x 1
3 1 809 865 245 HHCS 3/8-16 x 1 1/2
4 7 844 065 002 Stover Nut 3/8-16
5 10 945 867 242 Flat Washer Wide 3/8
6 12 948 767 132 Flat Washer SAE 3/8
7 1 610 902 026P This Instruction Sheet
Tools Required
Plug Lockout Boxes, Padlocks
Safety Glasses
Centerpunch, Power Drill, 13/32” Drill Bit
Pliers, Wrenches, Ratchet Handle, Sockets as required Installation Instructions
1. Remove and lockout main power plugs for
machine to be repaired and adjacent ma-
chines.
2. Remove existing hardware from brackets
and straighten bent/broken parts.
3. Inspect. Top of steel kickback should be
22” from the top of the pindeck. Steel
kickback should be parallel and even with
wooden kickback. There should be
approx. 3/8” gap between front end and
back end assemblies.
4. If necessary, loosen ball lift and track rail
hardware and adjust position of backend
assembly. Realign ball lift and track as
required and tighten hardware.
5. Using the repair bracket as a template,
centerpunch and drill holes in Back-End
bracket and Front-End frame.
6. Install repair brackets on both BE and FE.
For 82/90XL and later machines, wash-
ers will be necessary to shim between the
existing bracket and the repair bracket.
7. Breakage in this area can be caused by a
loose or missing Pit Mounting Bracket at
the back of the pinspotters. Check, re-
pair, or install as shown in your pinspotter
service manual.
8. Return area to operating condition, re-
move lockout boxes and test operation.
Pit Mounting Bracket
000 026 464
Jackscrew
Installation shown for
82/90XL pinspotter.