Using a third-party SIP phone with CallManager Express
Remove Highlighting
Has anyone successfully registered a third-party phone (like a
Grandstream or other) to CallManager express? If so do you have a
CME config? I'm trying to register some SIP devices to a CME (I've
been told it can be done), and cannot seem to find the right debugs
or anything to figure out what is wrong in my config!
matthnick at gmailFeb 26, 2009, 11:15 AM Post #2 of 3 (4326
views)
It looks like this: voice service voip sip registrar server
voice register global mode cme source-address x.x.x.x port 5060
max-dn X max-pool X voice register dn 1 number xxxx voice register
pool 1 id mac XXXX.XXXX.XXXX type ! ignore if 3rd party number 1 dn
1 username X password X Authentication is required if the phone's
IP address is in different subnet than the source-address.
-nick
PermalinkRe: Using a third-party SIP phone with CallManager
Express Remove Highlighting [In reply to]
On Thu, Feb 26, 2009 at 11:59 AM, Philip Walenta wrote: > Has
anyone successfully registered a third-party phone (like a
Grandstream > or other) to CallManager express? > > If so
do you have a CME config? > > I'm trying to register some SIP
devices to a CME (I've been told it can be
> done), and cannot seem to find the right debugs or anything
to figure out > what is wrong in my config! >
_______________________________________________ > cisco-voip
mailing list > cisco-voip [at] puck >
https://puck.nether.net/mailman/listinfo/cisco-voip > >
_______________________________________________ cisco-voip mailing
list cisco-voip [at] puck
https://puck.nether.net/mailman/listinfo/cisco-voip
mh at markhollowayFeb 26, 2009, 12:23 PM Post #3 of 3 (4321
views)
Here is an example of using Counterpath Bria with CME. I am
running CME with a SIP trunk upstream to Broadworks.
PermalinkRe: Using a third-party SIP phone with CallManager
Express Remove Highlighting [In reply to]
================================= Unified CME SIP endpoint
config ================================= voice register global mode
cme source-address 192.168.1.10 port 5060 max-dn 12 max-pool 12
authenticate register timezone 7 dialplan-pattern 1 7024305894
extension-length 4 ! voice register dn 1 number 7024305894 // This
can be the 4 digit TN; SIP Endpoint username
should contain 10 digit number IE. 7024305894 [at] 192 allow
watch name CounterPath Bria ! voice register pool 1 id mac
0018.8B06.1068 number 1 dn 1 presence call-list username 7024305894
password 555694 // Ensure credentials/authentication are in SIP-UA
for invite challenges (401 Unauthorized challenge-response) codec
g711ulaw
