2G BBULBE

PASS Instructions-5Replacement of Heater

Heater

Instructions

1. Take off water inlet and outlet fittings 2. Deflate spa

3. Remove cord grip with screwdriver 4. Remove the air pipe

5. Take out control box from spa pool 6. Remove the foam

7. Loosen the screws on the top lid 8. Remove the top lid

Instructions

Instructions

Bubble

Power input

Transformer input

Heater

Filter Transformer output

3 PIN-

water switch

2 PIN -Sensor

9. Disconnect the wires 10. SPA power panel

11. Remove the middle part of control box hull 12.Replace the heater

Instructions

13. Assembly the middle part of control box hull 14. Connect the wires

15. Put the top lid of control box 16. Put on the foam

Instructions

17. Assembly the control box 18. Pull out the air pipe through spa tub

19. Connect the check valve with spa tub 20. Screw back water inlet and outlet tightly

Instructions

Please give your valuable opinion!