+12v Constant = Blue/Yellow +12v Acc. Switch = Gray -12v Chassis Ground= Brown +12v Illumination = N/A +12v Dimmer = N/AAntenna/Amp Remote = Orange Can-Bus = LF+ = Pink

LF- = Purple RF+ = Lt. Green RF- = Blue LR+ = Black LR- = Yellow RR+ = Red RR- = White

Dash Type: CustomAftermarket Type: Single/Double DinKit: TA2058BHarness: TA02B/TA07SRAntanna Adapter: N/A

About the Vehicle

Make: ToyotaModel: CamryYear: 2007-10

In Dash Application

Wire Color Codes

Speaker Notes

Front Speaker Sizes

Rear

Toyota Camry

NOTES When installing aftermarket 5 ¼"or 6 ½" a speaker adapter is needed.

Dimensions:

Dimensions: W= 8-5/8'' L= 3''D= 5.75''

NOTES

Rear Deck: 6x9'' MidrangeSpeaker Adapter: SAT69Speaker Harness: TBAFactory ASsembly: (4) 10mm screws.

Standard/Optional

CD PlayerIn-Dash 6 Disc ChangerMP3 CompatibleJBL (440watt) Premium Sound System8-Speaker SystemBluetooth (Hands-Free)Auxiliary Input

W= 2-7/8'' L= 3.25''D= 3''

Type: Standard Audio System Location: At Speaker

Speaker Sizes

Front Dash: 2'' TweeterLower Door: 6X9” MidrangeSpeaker Adapter: SAT69Speaker Harness: TBAFactory ASsembly: (4) 10mm screws.

2007-10

Toyota CamryImages

Front Speakers

Rear Speakers

Radio removal

Front Speakers

Rear Speakers

1. Using a PRT remove tweeter speaker grill from dash.2. Extract (2) 10mm bolts securing the tweeter to the dash. Disconnect and remove.

1. Unscrew shifter handle and remove.2. Using a PRT remove shifter trim panel.3. Using a PRT remove trim panels on each side of the storage pocket below the HVAC controls. Extract (1) PHS from underneath each trim panel.4. Using a PRT remove entire top portion of the center consul in front of the arm rest. Disconnect and remove.5. Using a PRT remove upper A/C vents above the radio.6. Extract (4) 10mm bolts (2) above and (2) below

Radio

Front Tweeter

Recommended: Disconnect negative battery cable

Dash Tweeter

Door Speakers

1. Using a PRT remove side mirror trim panel.2. Using a hook tool remove inner trim from door release handle. Extract (1) PHS from behind trim panel.3. Using a PRT remove door arm rest handle trim panel. Extract (2) PHS from behind trim panel.4. Remove (1) panel fastener from the top front of the door panel.5. Using a PRT remove the door panel. Disconnect and remove.6. Extract (4) 10mm bolts securing speaker to the door steel. Disconnect and remove.

Door Speakers

1. Fold down rear seats.2. Using a PRT remove both "C" pillars.3. Using a PRT unsnap rear deck. Lift up then pull towards you to remove rear deck.4. Extract (4) 10mm bolts securing the speaker to the rear deck steel. Disconnect and remove.

2007-10