+12V Constant = LT. BLUE

+12v Acc. Switched = GRAY

-12V Chassis Ground = BROWN

+12V Illumination = DRK. GREEN

+12V Dimmer =

Amp Remote =

LF+ =

LF- =

RF+ =

RF- =

LR+ =

LR- =

RR+=

Dash Type :

Kit:Harness:Antenna Adapter: STD-ADT

Interface Adapter(s): N/A

About the Vehicle

Make: TOYOTA

Model: PRIUS

Year: 2005

In Dash Application

Wire Color Codes

Speaker Notes

Front Speaker Sizes

Factory Assembly: Plastic housing with (3) rivets.

Rear

PRIUSTOYOTA

2005

DIN AND A HALF

TBA

TBA

RR- =

Factory Assembly : Plastic housing with (3) rivets.

NOTES

Speaker Sizes

Dimensions:

Removing factory radio will no longer allow you to use some factory features. This includes the Climate control, Navigation, And factory JBL system. Other features may also be affected.

Dimensions: W= 5-5/8'' L= 5-5/8''D= 4-1/2''

NOTES

Rear Door: 1" tweeter Lower door: 6 ½ "Speaker Adapter: SAT6

OPTIONS

6 DISC CHANGERJBL PREMIUM SYSTEMDVD ONSTARBLUETOOTH

AMPLIFIER LOCATIONS: Located under passenger seat.

Aftermarket Kit: SINGLE DIN

W=L= D=

Center dash: 3" center channelMirror Pillar: 1" tweetersLower Door: 6 ½ " midrangeSpeaker Adapter: SAT6

TOYOTA2005 PRIUS

Images

Front Speaker

Tweet

1. Using a PRT unsnap inside mirror bezel, lift away disconnect and remove.2. Using a PRT unsnap door release cup inner panel, and extract (1) PHS from behind.3. Extract (1) PHS from door handle, lift away and remove.4. Using PRT unsnap the parimeter of door panel. Lift away, disconnect, and remove.

1. Unsnap (4) fastening clips securing speaker grill to dash bezel.2. Extract (2) PHS securing speaker to grill.

1. Using a PRT unsnap door release cup inner panel, and extract (1) PHS from behind.2. Extract (1) PHS from door handle, lift away and remove.3. Using PRT unsnap the parimeter of door panel. Lift away, disconnect, and remove.4. Extract (4) PHS to remove factory speaker from speaker adapter.

Radio removal

Front speaker

Rear speaker

1. Unsnap vent bezzel on right side of Radio.2. Unsnap vent bezel located on left side of steering wheel, and extract (1) PHS from behind.3. Extract (1) PHS from the panel directly under steering column. Unsnap lower steering column panel lift away disconnect and remove.4. Unsnap power button panel located above steering wheel, lift away, disconnect and remove.5. Unsnap vent bezel located on the left side of the Radio, lift away, disconnect and remove.6. Extract (2) PHS securing pocket trim bezel.7. Extract (2) 10mm hex bolts securing factory screen. Unsnap disconnect and remove

1. Using PRT pry off the plastic housing around the inside mirror pillar.2. Disconnect and remove.

Tweeter Removal

Radio

Rear Speakers

Front Dash