2001-2005 MAZDA Ml-5 PROJECTOR HEADLIGHTS INSTALLATION INSTRUCTIONS

TOOLS AND SUPPLIES REQUIRED

Y." Drive Ratchet

10mm Socket

Phillips Screwdriver

Trim Pad Remover

Product Part Numbers:

LHP-MX501JM-TM

LHP-MX501-TM

If your Headlight is Halo type, you also need: 4 Blue Male Quick Wire Connectors

Wire Stripper 4 Blue Female Quick Wire Connectors

Wire Crimper 2 Red Wires (8 inch)

4 Blue Quick Splice Wire Connectors 2 Black Wires (8 inch)

1. Clips and bolts locations

3. Remove the clips that may be in these locations

2001-2005 MAZDA Ml-5 PROJECTOR HEADLIGHTS INSTALLATION INSTRUCTIONS

2. Plastic clips location

4. Remove the clips that may be in these locations

5. Remove the phillips head screw 6. Unplug the bumper light

8. (4) 10mm bolts location

9. Remove the (4) 10mm bolts 10. Tug on the side of the front bumper to unclip

11. Remove front bumper 12. Remove (2) 1 Omm bolts

14. Unplug headlight harness

15. Unplug headlight harness 16. Remove the hadlight

17. Plug in new headlight to headlight harness

Please see the Halo and L.E.D installation instruction If your headlights don't have HALO or L.E.D. You can skip it

21. Tighten (2) 1 Omm bolts

18. Connect New headlight to harness

20. Place New projector headlight

22. Replace front bumper

23. Tighten (4) 10mm bolts 24. Reconnect bumper light

26. Tighten phillips head screw

27. Replace clips that may be in these locations 28. The installation is now completePlease repeat the step in order from 1 to 27 for the opposite side