Upload
others
View
36
Download
1
Embed Size (px)
Citation preview
2-Beginning Leather Carving with Kay Orton
(Use this page with the Beginning Leather Carving video)
The tools we are using here are the seven basic leather cra� tools from Tandy Leather Company.
There are many leather cra� tool makers and many sizes of these basic tools so your tools may look a li�le
different than the tools pictured here and in the video. That is ok. The size of the tool will need to vary with
the size of the pa�ern. This pa�ern works best with medium sized basic tools.
Supplies you will need—A hard surface——A piece of marble or granite is best,
A spray bo�le for water or a sponge & water, Vegetable tanned Leather (tooling leather)
Leather tools, a mallet, tracing tool, tracing film, pencil to copy pa�ern, the tracing pa�ern
Tracing Stylus
Pear Shader—-checked or smooth Camoflage tool
checked beveler or smooth beveler Veiner
Backgrounder Seeder
Swivel Knife
Modeling tool for tracing- with a spoon on one end for modeling or molding leather
4444----H exhibit Unit 2 requirements H exhibit Unit 2 requirements H exhibit Unit 2 requirements H exhibit Unit 2 requirements
Sample 1-Swivel Knife & camouflage
Sample 2– Steps used in Sample 1 and pear shader, beveling & veiner
Sample 3– Steps used in sample 1 & 2 and seeder, backgrounder, & Decorative cuts
Small flower & leavesSmall flower & leavesSmall flower & leavesSmall flower & leaves——A carving pattern that could be used in Unit 2
Use of backgrounder Use of veiner & seeder Use of beveler
Use of camouflage tool Tracing pattern
Use of swivel knife
Use of pear shader
The size of this pattern is 2 1/4 inches x 3 1/2 inchesThe size of this pattern is 2 1/4 inches x 3 1/2 inchesThe size of this pattern is 2 1/4 inches x 3 1/2 inchesThe size of this pattern is 2 1/4 inches x 3 1/2 inches