Upload
others
View
3
Download
0
Embed Size (px)
Citation preview
1.Remove four screws here.
2.Remove this screw.Then you can remove the small
emitter screen like next photo.
3.Disconnect this part.
拆 2 4.Disconnect thesetwo parts.
5.Disconnect this part between thermocouple and valve.
6.Remove these
two screws.
7.Replace with
new
thermocouple.
8.Put the thermocouple and ignition needle in place.
9.Tighten the screws..
10.Use screws to assemble the wind baffle.
'
11.Connect these four parts.Then assemble the small
emitter screen.