Upload
dangphuc
View
218
Download
0
Embed Size (px)
Citation preview
Issue 2
Date: 23-02-10
1
1250 Lowbed Rail Transporter
� Deck Length - 12.36m.
� Engine: Deutz Diesel, Euro 3 Spec - TCD 2015, 500kw V8 Engine.
� Capability: 50kmh up to 1:40 gradient. Able to traverse 1:33 gradient at lesser speed.
� TARE Weight: 29.6T.
� Payload: 30T.
� Container Capability: 2 x 20ft ISO containers or 1 X 40ft ISO Container.
� Crane: PK36002 35mT (meter-Tons) with SKE 2.5 winch.
� Improved access for maintenance with hydraulically tilt-able cabin & engine canopy
� Compliance with standards: NRSS-6, AAR, AWS D15.1, AS2312, AS1319 and AS1906-1.
Layout:
MANCO RAIL IS A TRADING DIVISION OF MANCO ENGINEERING & EQUIPMENT COMPANY
LTD
P.O. BOX 58 609, BOTANY, MANUKAU 2163, 139 CRYERS ROAD, EAST TAMAKI, AUCKLAND, NEW ZEALAND
TELEPHONE 64-9-274 9862 FACSIMILE 64-9-274 7393
Issue 2
Date: 23-02-10
2
Deck: Checker plate, coated with hard wearing two pot paint and non-slip grit.
Rope Rails Deck tie Downs
Twistlocks
Issue 2
Date: 23-02-10
3
Modular Concept - Drive Bogie:
Bogies fitted with suspension, brake calipers and Rexroth A6VM drive motors coupled to PD1090/MR1/5.05
epicyclic gearboxes via a ‘quick disengage’ dog clutch.
‘Quick disengage’ dog clutch.
Drive bogie park/service brake setup.
1.5” Triplex Chain with tensioner and anti-vibration
spring.
Spring with crossmember longitudinal and lateral
stops
Issue 2
Date: 23-02-10
4
Modular Concept – Non-Drive Bogie:
Bogie Fabrication with axle assemblies fitted.
Bogie with suspension, brake calipers and brake pots.
ABS Pole wheel and sensor (both bogies, all axles).
Non-Drive bogie caliper/brake pot setup.
AAR Spec ‘Class-D’ Timken Bogie Bearings
Issue 2
Date: 23-02-10
5
Modular Concept – Power Pack:
Power pack frame with engine & hydraulics.
Powerpack ‘in situ’ with Bonnet partially raised
Colpro ‘residential’ stainless steel silencer/purifier.
Extensive use of steel tube in hydraulic plumbing,
giving more efficient use of space and a higher line
life than hoses.
Powerpack Components: Deutz TCD2015 engine fitted with;
Flywheel primary ‘drive pump’:
Rexroth A4VG250EP4D1
Flywheel secondary ‘crane pump’:
Rexroth A11V095DRS
Flywheel tertiary ‘flushing pump’:
Rexroth PG2AS
PTO driven ‘gearbox flush pump’:
Rexroth PG2AS
Issue 2
Date: 23-02-10
6
Modular Concept – Power Pack cont. :
Engine view from ‘cabin side’; 600CC air compressor
with cooling coil.
Viewing drive pumps ‘end on’ with respective feed
lines.
Easy access to pumps and hoses for maintenance.
Effective hose layout for clean, short lengths.
Issue 2
Date: 23-02-10
7
Modular Concept - Cabin
Cabin rear corner, excellent all-round visibility.
Rear window and ‘skylight’ for good crane visibility.
Driver seat in ‘ramp end first’ drive position.
Driver seat in ‘cabin end first’ drive position.
Easy access controls.
Bright cabin interior lighting.
Fitted with split system, filtered
air conditioning.
Issue 2
Date: 23-02-10
8
Modular Concept – Cabin cont. & Crane
Cabin tilted forward for service
Palfinger PK36002 Crane
Crane ‘hooks box’ on lower left hand side
Diesel filler cap in lower center
Palfinger PK36002 crane fitted with winch’.
Crane lamp fitted on right hand side.
Issue 2
Date: 23-02-10
9
Misc
Substantial steel conduit for
electrical and air lines; - Good protection from flying ballast.
- Open bottom for moisture drain.
- Rubber lined edges to eliminate cable/hose
chafing.
Hooks box for crane hooks
storage.
-Ramp rams ‘fail safe’ with counterbalance
valves.
-All lights fitted into rear crossmember.
-Cameras positioned on ramp, remain pointing
horizontally regardless of ramp angle.
Power box with battery master switches and DC
pump controls.
Cameras on each ramp for rearward visibility on
cabin internal LCD screen.