1

Disassembly

1

2

Warning●Sharp objects

●Do not attempt to eat or swallow

Warning●Possible toxic chemicals

●Do not attempt to eat or swallow

Warning●Sharp objects

●Wear gloves if possible

Note●Small objects may

get lost easily

●Have a container handy

2

3

Thank you for purchasing the

Iwata 9000 Dual-Action Airbrush!

Disassembling your airbrush can be a daunting task if undertaken alone.

In this instruction manual we will detail all the steps of the I-9000’s disassembly for the purposes of cleaning and parts removal or replacement.

Please follow each step in sequence to make things easier for yourself.

3

4

Page 1- Cover Letter

Page 2- Hazards

Page 3- Introduction

Page 4- Table of Contents

Page 5- Tools/Equipment Required

Pages 6-15- Disassembly Steps

Page 16- Contact Us

5

Airbrush wrench

Small shoebox or container

Small piece of styrofoam

Your I9000

6

Disassembly StepsStep 1- Locate and hold your

airbrush.

Step 2- Pull the paint jar/reservoir from your airbrush.

6(Return to Table of Contents.)

7

Disassembly StepsStep 3- Unscrew the cap of

your paint jar. (You may use both hands if you wish.) Paint jar disassembly will be complete.

Step 4- Set the unscrewed jar aside in a safe place.

7(Return to Table of Contents.)

8

Disassembly StepsStep 5- Hold your

airbrush with one hand.

Step 6- Holding the front of the airbrush steady, untwist the back of the airbrush.

8(Return to Table of Contents.)

9

Note: After removing, the back half should look like this.

Step 7- Hold the retaining screw carefully and unscrew the needle assembly while holding it over your shoebox.

9

Disassembly Steps

(Return to Table of Contents.)

10

Step 8- Making sure the airbrush is over a container like the shoebox, remove your airbrush needle.

Note: A very small retaining spring will fall into your shoe box.

10

Disassembly Steps

(Return to Table of Contents.)

11

Note: The piece will look like this. Place it in your airbrush jar for safekeeping.

Step 9- Hold your airbrush needle.

Disassembly Steps

(Return to Table of Contents.)

12

Step 10- Unscrew the rear retaining nut. Place the assembly in shoe box.

Step 11- Remove the retaining screw by sliding it off of the back end of the needle.

Disassembly Steps

(Return to Table of Contents.)

13

Step 12- Place your needle sharp end down into the styrofoam OR in your airbrush jar sharp end up for safekeeping.

Note: Please be extremely careful when handling your airbrush needle. It is damaged VERY easily.

Disassembly Steps

(Return to Table of Contents.)

14

Step 13- Remove your main control lever by lifting it out of the assembly.

Step 14- Use your wrench to unscrew the jet nozzle counterclockwise.

Disassembly Steps

(Return to Table of Contents.)

15

Step 15- Remove the nozzle and place it in a box for safe keeping.

Congratulations! Disassembly is complete!

Disassembly Steps

(Return to Table of Contents.)

16

Contact Us:Mailing Address Iwata Airbrush Distributors 3203 Market Plaza Suite #23 Balevore, Massachusetts 91311-1234Email Iwatahelp@customersupport.iwata.bizPhone 1-888-802-1234 ext. 3045

(Return to Table of Contents.)