SAP Note
Header Data
Symptom
1. You release a sales document from a credit block.
2. You carry out a recheck for a sales document (in the
background using report RVKRED09 or in a credit list, for example
using transaction VKM1).
This triggers the availability check (ATP) for the entire
document. You cannot tell which items are included in the
availability check.
Other Terms
Availability, Available-to-Promise, ATP check, VKM1, VKM3, VKM4,
credit release, PORE, BVFP, FORM FCODE_PORE, FORM FCODE_BVFP,
MV45AF0F_FCODE_PORE, MV45AF0F_FCODE_BVFP
Reason and Prerequisites
1. The confirmed quantities are usually reset when a credit
block occurs for a sales document. This means a new availability
check is triggered for the entire document when it is released from
the credit block.
2. During the recheck, the system carries out an availability
check before it runs the credit check, so the current confirmed
quantities are available for the credit limit check.
A decision regarding whether to perform the availability check
is made for each item.
l The item does not have any confirmed quantities (VBAP-KBMENG =
0). -> The availability check is performed.
l The item is confirmed either wholly or partially (VBAP-KBMENG
> 0). -> The availability check is not performed.
l The item is partially delivered and the confirmed quantity is
higher than the delivered quantity (confirmed quantity - delivered
quantity = 0). -> The availability check is performed.
l The system carries out a product selection for the item. ->
The availability check is performed.
l The item belongs to a scheduling agreement with releases
(component supplier). -> The availability check is
performed.
Solution
If you want your system to behave differently from the standard
logic, you can use the user exit USEREXIT_AVAIL_CHECK_CREDIT in the
include MV45AFZF. With the user exit you can:
l ... Execute the availability check in all scenarios.
l ... Call the availability check in accordance with the
standard logic, as described above (the default setting).
l ... Skip the availability check.
The user exit is processed for each item which means a decision
can be made for each item. When a recheck takes place, the
availability check is carried out before the credit check.
Therefore, the new credit status is not yet available in
USEREXIT_AVAIL_CHECK_CREDIT.
1324433 - Availability check during credit block release
Version 3 Validity: 08.04.2010 - active Language English
Released On 08.04.2010 15:09:47 Release Status Released for
Customer Component SD-BF-CM Credit Management Priority
Recommendations / Additional Info Category Consulting
