0

Hosted by Nebraska DOT

IHEEP 2018 President – Jon Starr

EXPERIENCED25 years of software development expertise to support AEC professionals.

TRUSTEDUsed in over 100 countries and by thousands of engineers and architects worldwide.

INNOVATIVEConsistently enhancing and developing our product line while providing tailor-made solutions to meet 21st century design challenges.

DOTs & LOCAL GOVERNMENTSOver 86% of the US DOTs, and over 300 US cities and counties have standardized on Transoft Solutions’ products.

UNIVERSITIESPenn State, University of California Irvine, University of Florida, University of Wyoming, Purdue, Iowa State, Virginia Tech, North Carolina State, and many others.

AEC CONSULTANTSOver 90% of the ENR Top 100 Transportation firms use Transoft Solutions’ products.

TRANSPORTATION RESEARCH GROUPS & ASSOCIATIONSAASHTO, ITE, IHEEP, TRB, and others internationally.

September 24, 2018

Presented by: Johann Flores, Product Manager, Transoft Solutions

2D vehicle movement spatial checking is standard.

• Used to be done with static templates

• Now done with computer simulations

3D ground clearance checking is not standard.

• Granted, it’s not applicable in all scenarios but there are some checks that should be made mandatory

• This is difficult to check.

What can happen when 3D audit is incomplete or not carried out?

• Vehicle damage

• Increased maintenance budget for facility

• Re-work

• Litigation.

• AutoTURN Pro utilizes artificial intelligence and 3D technology to enable faster modeling of even the most complex terrain and vehicles.

• AutoTURN Pro is ideal for modeling and analyzing multiple scenarios with potential terrain and overhead conflicts.

AutoTURN Full Adoption

AutoTURN Pro Full Adoption

AutoTURN Pro Adoption

AutoTURN Pro Evaluation

No Current Activity

MN

(Procedure assumes surface has already designed and is present.)

1. Ascertain worse case scenario 3D movements (e.g. worse case trailer chording effect).

2. Configure low clearance vehicle model.

3. Generate 3D vehicle movement on designed surface.

4. Generate reports for analysis:1. Longitudinal2. Cross-sectional

5. Use findings to make revisions.

6. Re-check 3D movements for clearances.

• 3D auditing of grading designs is important.

• There are a range of consequences in foregoing this check.

• AutoTURN Pro gives you the tools to accomplish 3D checking.

• Simple workflow.

• Feedback allows you to make informed (necessary) changes.

Transoft Solutions Inc.250-13575 Commerce Parkway

Richmond, BC ,CanadaV6V 2L1

tel | +1.604.244.8387toll free | + 1.888.244.8387email | info@transoftsolutions.comweb | transoftsolutions.com

Johann FloresProduct Manager, Design BUjf@transoftsolutions.com