Upload
hope-singleton
View
303
Download
2
Embed Size (px)
Citation preview
三新電気香港有限公司三新電気香港有限公司
SANSHIN DENKI HK CO., LTDSANSHIN DENKI HK CO., LTD
Technical InformationTechnical Information
• Difference of production methodDifference of production method• Characteristic of our product Characteristic of our product • OthersOthers
XENON FLASH TUBEXENON FLASH TUBE
SPEC COMPARISONSPEC COMPARISON
CONTENTSCONTENTS Comp.WComp.W Comp.Comp.PP
S/KS/K
11NOISENOISE GoodGood BetterBetter
22 High Pressure High Pressure (PA)(PA)
About About 2.52.5
2.52.5
33 Size (Ark length)Size (Ark length) 8mm8mm N/AN/A
CHEMBERCHEMBER METHODMETHOD
Company P,Company P,Company WCompany W
At the time of putting At the time of putting airair
pressure into xenon pressure into xenon tubes,tubes,
about 30pcs of XE about 30pcs of XE tubes tubes
are put into a pot at are put into a pot at the the
same time. It is sealed same time. It is sealed byby
heater at the same heater at the same time. time.
CHEMBER METHODCHEMBER METHOD MERITS/DEMERITSMERITS/DEMERITS
MERITS :MERITS :** The outputs produced at the same time are The outputs produced at the same time are
largelarge
** xenon tube at required color temp is lowxenon tube at required color temp is low
DEMERITS :DEMERITS :** There is much dispersionThere is much dispersion
** Only 2.5 atmospheric pressure can not put Only 2.5 atmospheric pressure can not put inside the pot.inside the pot.
INDEX METHODINDEX METHOD (新光和)(新光和)• Produced one by Produced one by
oneone
• When xenon tube is When xenon tube is sealed, it is done by sealed, it is done by burner. And then burner. And then they are dipped into they are dipped into the Liquid Nitrogen the Liquid Nitrogen to cool it down at to cool it down at the momentthe moment. .
Tungsten expands, Tungsten expands,
glass shrinksglass shrinks..
↓↓** Slow leakage of GasSlow leakage of Gas
is hard to cause.is hard to cause.
** High Pressurization of High Pressurization of the enclosure gas is the enclosure gas is easily possible.easily possible.
THAT MEANS YOU THAT MEANS YOU CANCAN
GET MORE FLASHING GET MORE FLASHING LIGHT POWER!LIGHT POWER!
CHARACTERISTICCHARACTERISTICSS
• 1. Compression seal by the combination of the hard 1. Compression seal by the combination of the hard glass glass
and the tungsten electrode is adopted. and the tungsten electrode is adopted.
• NO CHANGE OF THE SEAL(NO CHANGE OF THE SEAL( 経時変化無)経時変化無)• RESISTANT TO THERMAL SHOCK(RESISTANT TO THERMAL SHOCK( 熱衝撃強)熱衝撃強) • 2.The high-performance cathode sintering(2.The high-performance cathode sintering( 高性能陰極高性能陰極
焼結体焼結体 ).). •
• TRIGGER POINT BECOMES STABLETRIGGER POINT BECOMES STABLE• LITTLE DEFORMATION OF TRIGGER WAVE FORMLITTLE DEFORMATION OF TRIGGER WAVE FORM• NOISE IS HARD TO CAUSENOISE IS HARD TO CAUSE• TRIGGER LEAKAGE IS HARD TO CAUSETRIGGER LEAKAGE IS HARD TO CAUSE
CHARACTERISTICCHARACTERISTIC
SS• 3. There are a few drifts caused by the life 3. There are a few drifts caused by the life deterioration. deterioration. 4. High pressurization of the enclosure 4. High pressurization of the enclosure gas is easily possible. gas is easily possible. 5. Nesa-coat of the high heat-resistance is 5. Nesa-coat of the high heat-resistance is usedused..
PRODUCTION CAPACITYPRODUCTION CAPACITY
1 Line capacity1 Line capacity
220Kpcs/220Kpcs/MonthMonth
2 Line capacity2 Line capacity
440Kpcs/Month440Kpcs/Month
1 1 SHIFTSHIFT
220Kpcs/220Kpcs/MonthMonth
440Kpcs/Month440Kpcs/Month
2 2 SHIFTSHIFT
440Kpcs/440Kpcs/MonthMonth
880Kpcs/Month880Kpcs/Month
3 3 SHIFTSHIFT
660Kpcs/660Kpcs/MonthMonth
1320Kpcs/Month1320Kpcs/Month
PRESENT PRODUCTION PRESENT PRODUCTION QUANTITYQUANTITY
0
100,000
200,000
300,000
400,000
500,000
600,000
2 月 3 月 4 月 5月 6月 7月 8月 9月
国内