(Restorative Dentistry and Endodontics: Case Report)

Title of your paper (capitalize only the first letter of the whole phrase)

First Author,1,2 Second Author,2 Third Author3,*

1First affiliation, City, Country

2Second affiliation, City, Country

3Third affiliation, City, Country

Running Title: Limit 60 Characters

Last name and initials of the authors(s).

*Correspondence: Author name, Academic degrees

Affiliation, Street Address, City, Postal code, Country

E-mail: , Tel: +Country code-xxxx-xxxx , Fax: +Country code-xxxx-xxxx

ORCID

Byeong-Hoon Cho http://orcid.org/0000-0001-9641-5507

Funding

ABSTRACT

Keywords: A; B; C; D; E; F

INTRODUCTION

Manuscripts should be submitted in Microsoft Word files. They should be typed and double-spaced, using font Arial, size 10 with margins of 25 mm on each side and 30 mm for the upper and lower ends on A4 size paper.

Abbreviation

The use of acronyms and abbreviations is discouraged and should be kept to a minimum. When used, they are to be defined where first used, followed by the acronym or abbreviation in parentheses.

Citation of reference

References should be numbered consecutively in the order in which they are first mentioned in the text. Each reference should be cited as [1], [1,4], or [1-3]. When quoting from other sources, give a reference number in brackets after the author’s name or at the end of the quotation. Examples are as follows:

-Kim [1]

-Bernstein and Horbar [2]

-Bradin et al. [3]

CASE REPORT(S) (primary section heading)

Primary section headings should be left justified, with all letters capitalized.

Subsection headings should be structured as follows:

Secondary subsection heading

Tertiary subsection heading

Quaternary subsection heading:

TITLE

Title

1. Title

1) Title

(1) Title

① Title

i) Title

Tables and figures should be indicated in the main text as follows:

(Table 1), (Tables 1 and 2), (Tables 1-3), (Figure 1A and 1B), (Figure 1A-1C), (Figures 1 and 2), (Figures 1-3), (Figures 1A and 3B), (Table 1, Figure 2).

DISCUSSION

CONCLUSIONS

Author Contributions

Conceptualization: name. Data curation: name. Formal analysis: name. Funding acquisition: name. Investigation: name. Methodology: name. Project administration: name. Resources: name. Software: name. Supervision: name. Validation: name. Visualization: name. Writing - original draft: name. Writing - review & editing: name. (name: the last name and initials, e.g., Cho BH)

CONFLICT OF INTEREST

If there are any conflicts of interest, authors should disclose them in the manuscript.

ACKNOWLEDGEMENTS

Persons or institutes that contributed to the papers but not enough to be coauthors may be introduced. Funding information should be described along with other types of support, if any.

REFERENCES

References should not exceed 40.

Journal

(Author(s). Title. Journal name [Abbrev.] Year:Vol;Page.)

1. Zara S, Di Giulio M, D'Ercole S, Cellini L, Cataldi A. Anti-adhesive and pro-apoptotic effects of 2-hydroxyethyl methacrylate on human gingival fibroblasts co-cultured with Streptococcus mitis strains. Int Endod J 2011;44:1145-1154.

2. Porto IC, Oliveira DC, Raele RA, Ribas KH, Montes MA, De Castro CM. Cytotoxicity of current adhesive systems: in vitro testing on cell cultures of primary murine macrophages. Dent Mater 2011;27:221-228.

3. Esteves CM, Ota-Tsuzuki C, Reis AF, Rodrigues JA. Antibacterial activity of various self-etching adhesive systems against oral streptococci. Oper Dent 2010;35:448-453.

Book

(Author(s). Book title. Edition. Place: Publisher; Year. Page numbers)

Seltzer S, Bender IB. The dental pulp: biologic considerations in dental procedures. 3rd ed. Philadelphia: Lippincott; 1984. p400.

Book chapter

(Chapter author. Chapter title. In: editor(s). Book Title. Edition. Place: Publisher; Year. Chapter or page.)

Senel S, Kas HS, Squier CA. Application of chitosan in dental drug delivery and therapy. In: Muzzarelli RAA,

editor. Chitosan per os: from dietary supplement to drug carrier. Atec: Grottammare, Italy; 2000. Chapter 13.

Web site

(Authors’ name: Website title [Internet]. Place: Publisher; Copyright year. Available from: URL. (updated Year Month Date))

American Cancer Society. Cancer Reference Information [Internet]. Atlanta (GA): American Cancer Society; c2010. Available from: http://www.cancer.org/docroot/CRI/CRI_0.asp. (updated 2014 Nov 21).

Other types of references not described below should follow The NLM Style Guide for Authors, Editors, and Publishers (http://www.nlm.nih.gov/citingmedicine.).

FIGURE LEGENDS

(sample)

Figure 1. Histologic presentation of the biphasic calcium phosphate (BCP)/absorbable collagen sponge group after 4 weeks of healing. (A) New bone is seen in close contact with the graft material. (B) BCP particle is absorbed without inflammation (A: H&E; B: H&E, bar=xxx nm). arrowheads, defect margin; NB, new bone.

(Figure guide)

You should not attach figure files in the manuscript. Instead, you should upload your figure files, each figure as separate file, to our e-submission system while submitting your paper.

Figures should be submitted in Tiff or JPEG file format and they will be automatically attached at the end of the manuscript in PDF. Number figures as Figure 1, Figure 2 … in order of citation in the figure legend. An individual should not be recognizable in the photographs unless a written consent of the subject has been obtained and is provided at the time of submission. Scales should be presented as a bar in the picture or as a magnification remark in the legend.

Except for especially complicated drawings that show large amounts of data, all figures are published at one page or one column width; when the figures are reduced to the size of a single column or of a single page width, the smallest parts of the figure must be legible.

It is recommended to size original figure widths to 4 inches wide. The minimum requirements for digital resolution are:

• 900 DPI/PPI for black and white images, such as line drawings or graphs.

• 300 DPI/PPI for picture-only photographs.

• 500 DPI/PPI for photographs containing pictures and line elements, i.e., text labels, thin lines, arrows.

TABLES sample

Table 1. Comparison of Knoop microhardness values (Mean±SD) between the chelating solutions and between storage times.

Solution

Result of two-way ANOVA

Control

EDTA

Chitosan (glass)

Chitosan (plastic)

Time

0

43.1 ± 2.9Aa*

26.7 ± 5.1Ba

32.4 ± 5.8Ba

37.5 ± 5.0Ba

Main effect:

Solution, p < 0.0001

Time, p = 0.113

Interaction effect:

Solution x Time, p = 0.329

7

45.6 ± 5.8Aa

23.7 ± 5.1Ba

29.8 ± 3.8Ba

30.8 ± 4.0Ba

15

33.7 ± 4.3Aa

33.6 ± 3.9Ba

26.9 ± 5.7Ba

31.5 ± 3.6Ba

30

38.2 ± 3.5Aa

28.5 ± 5.6Ba

34.8 ± 4.8Ba

26.2 ± 3.0Ba

45

36.8 ± 5.9Aa

28.4 ± 2.2Ba

27.3 ± 1.6Ba

27.4 ± 3.2Ba

60

37.3 ± 3.9Aa

27.7 ± 2.6Ba

27.1 ± 1.1Ba

26.2 ± 2.2Ba

90

38.2 ± 3.4Aa

26.1 ± 2.3Ba

26.9 ± 1.3Ba

25.8 ± 2.7Ba

120

41.0 ± 1.0Aa

24.6 ± 2.2Ba

27.8 ± 2.0Ba

27.6 ± 2.3Ba

150

41.4 ± 0.9Aa

30.3 ± 2.4Ba

31.1 ± 1.4Ba

31.4 ± 3.2Ba

180

38.1 ± 3.0Aa

27.1 ± 2.5Ba

29.8 ± 2.1Ba

30.2 ± 1.2Ba

The values are mean ± SD.

EDTA, ethylenediaminetetraacetic acid; SD, standard deviation.

*Different capital letters in the same column represent statistical significant difference between groups. Different lower case letters in the same line represent statistical significant difference between groups. (Tukey-Kramer test)

(Table guide)

Each table should be typed in a separate sheet. The title of the table should be placed on top. The first letter of the first word should be capitalized and a period should be placed at the end of the title. Tables are numbered in order of citation in the main text. Only horizontal lines should be used within a table, to distinguish the column headings from the body of the table, and immediately above and below the table. Lower case letters in superscripts a, b, c ... should be used for special remarks.

(Figure sample)

Figure 1.

�-Author’s full name should be provided in order of first, middle, and last name.

-The superscript asterisk (*) sign should be given to the corresponding author after comma.

-Do not write authors’ degrees and positions.

�e.g., Ahmed HMA, Luddin N, Kannan TP, Mokhtar KI, Ahmad A

�Please refer to ORCID (� HYPERLINK "http://orcid.org" �http://orcid.org�) and provide ORCID code for every authors.

�Non-structured format of abstract

-Limit 200 words.

�Keywords should be main heading terms of MeSH (� HYPERLINK "https://www.nlm.nih.gov/mesh/MBrowser.html" �https://www.nlm.nih.gov/mesh/MBrowser.html�) in an alphabetical order.

-Limit 6 keywords, separated by semicolons.

�Case reports should be structured as following section headings:

INTRODUCTION

CASE REPORT(S)

DISCUSSION

CONFLICT OF INTEREST

ACKNOWLEDGEMENTS

AUTHOR CONTRIBUTION

ORCID

�Read these brief guides and overwrite from here.

�The contributions of all authors should be described in cover page of the manuscript using the CRediT Taxonomy of author roles. They should be precisely reflected as following 14 categories: Conceptualization, Data curation, Formal analysis, Funding acquisition, Investigation, Methodology, Project administration, Resources, Software, Supervision, Validation, Visualization, Writing – original draft, Writing-review & editing.

All authors must meet at least one of the seven core contributions (Conceptualization, Data curation, Formal analysis, Investigation, Methodology, Software, Validation), as well as at least one of the writing contributions (Writing - original draft preparation, Writing - review & editing). Authors could also satisfy the other remaining contributions; however, these remaining contributions alone would not qualify them for authorship.

An individual author may be assigned multiple roles, and a given role may be assigned to multiple authors. It is recommended that corresponding authors bear the responsibility for role assignment of all authors who should be given the opportunity to review and confirm their assigned roles.

�If there are no conflicts of interest, authors should insert the following sentence.

“No potential conflict of interest relevant to this article was reported”.

�The order should be described as follows; authors' names (including all co-authors). Title. journal name(Abbrev.) the year;volume:and page numbers (e.g., 445-461.) or chapter number(s).

�A legend for each light microscopic or electron microscopic photograph should include name of stain with internal scale description. Magnification rate is not recommended.

�Lower case letter, italic

�Sequence of footnote is as follows:

General description on the data in the table, if needed

Abbreviations

Explanation about the symbols

- 9 -