Pouch Burst / Compression

Pouch Burst Tester / Pouch Compression Tester (Static + Dynamic Load Tester )

Electro-Hydraulic model with constant rate of travel.

Suitable for testing the Seal Integrity of Liquid / Gas Filled - Pouches / Saches / Blisterpacks.

Suitable for 3 ml – 1,500 ml or larger packs.

Models Available :

Sr No. Description Model # H300D Model # H500D

1 Capacity 300 Kgf 500 Kgf

2 Least Count / Resolution 0.1 kgf 0.5 kgf

3 Accuracy (0.2% of Full Scale) 0.6 Kgf 1 Kgf

Specifications / Features :

Digital model with load cell based system

With backlit LCD Display

With Embedded Push Buttons on control panel.

Peak hold facility for registration of maximum reading.

With auto-calibration facility.

- Standard Platform size :

L= 200mm x W= 200mm x H=50mm

- Large Platform size :

L= 350mm x W= 250mm x H=100mm

Note : Other models, capacities and sizes also available.

This equipment is suitable for :

1) Dynamic Load Test (Destructive Mode)

Test Type : Press till failure

In this method, the sample is compressed until the pouch bursts.

2) Dynamic Load Test (Non-Destructive Mode)

Test Type : Press till Load Setpoint. Then release.

In this method, the sample is compressed only upto the Load setpoint Pre-Determined by the user. If

the pouch bursts before the set-point is achieved, then this becomes a destructive test. The machine

automatically stops on sample failure or when the preset-load is achieved. Whichever is earlier.