Lake  Fountain  5-­‐Step  Install  Guide  

Step  1:  Connect  Fountain  

Underwater  connector  model.  

•  Bring  power  cable  up  through  center  float  opening.  

Hardwired  model.  

•  Lower  power  cable  through  center  float  opening.  

NOTE:  See  intake  screen  DIY  if  that  op8on  is  purchased  before  performing  these  steps.    

Step  2:  Orient  &  Uncoil  

Underwater  connector  model.  

•  Orient  connectors  and  hand  Eghten.  

Hardwired  model.  

•  Lower  power  cable  through  float  and  uncoil.  

NOTE:  See  intake  screen  DIY  if  that  op8on  is  purchased  before  performing  these  steps.    

Step  3:  Lower  in  Float  

•  Both  Models.  Lower  in  float.  

Step  4:  Run  Power  Cables  1.  Moor  float    2.  Run  power  cable  to  shore.  

2  

1  

Step  5:  Connect  Power  

1.  120  VOLT  Single  Phase  Timer  (Plug  in  model)  

2.  240  VOLT  Single  Phase  Control  Panel  (electrician  required)  

3.  Three  Phase  Control  Panel  (electrician  required)  

2  

1  

3  

WOW!  You  did  it.  

Share  your  DIY  WOW!  Take  a  picture  or  video  and  submit  your  Talent  HERE!  

If  you  have  problems  with  your  install  call  us  at:  1-­‐888-­‐211-­‐3548