8/2/2019 High Speed Mixer
1/2
TRODUCTION :
eating Cooling mixer is suitable for rigid PVC Dry Blends. It is
a combination of High Speed Mixer Cooler Mixer .The mixing dthe
high Speed Mixer and transferred to Cooling Mixer for quick
cooling. The set consists of mixing vessel, cooling ve
pecial designed mixing blades, electric motors and control
panel.
PECIFICATIONS :
IGH SPEED MIXER : Fabricated cylindrical mixing vessel made of
stainless and jacketed by mild steel sheet. The jaonstruction
permits to control the frictional heat by circulation of cold
water. If a shorter mixing is required, then circulatesl through
jacket. The top cover is made of mild stainless steel with
impregnated gasket fixer on container to prevent leakuring mixing
operation. The complete mixing vessel and motor is mounted on
sturdy fabricated steel of standard sections.
EARING HOUSING : Main drive shaft is mounted on anti bearing on
frame below mixing vessel. Mechanical rotary sealsrovided to
prevent the resin leakage during mixing operation. Water
circulation is provided with spiral jacket to maintain beamperature
and high temperature 500C grease is being used to bearing and
housing for long life as well as minimum frictieat and
maintenance.
OLD BLENDER : Cooling mixer is suitable for fastest cooling of
directly transferred Rigid PVC Blends from High Speed Mhe special
designed cooling blade. Internal cooling ring and outer jacket
spiral cooling systems are result of fastest cooling.
OOLING VESSEL: Cylinderical shape cooling vessel made of
stainless and jacked by mild sheet. Outer jacket is reinforced
piral strip to circulate water all around the SS vessel for maximum
heat transferred as well as it gives strength to SS vessel ottom
part of vessel is also reinforced to avoid bulging and give proper
circulation to the water. A cooling ring provided atenter portion
of vessel for faster and efficient cooling of compound. The top
cover is made of stainless steel having swing penable arrangement.
The complete cooling vessel is mounted on the fabricated steel
frame of standard sections.
LADES : Made of stainless steel and special designed to give
proper movement to the compound for shorter cooling cycle.
SCHARGE : Pneumatic cylinder is provided to discharge spoul of
cooling mixer compound can directly filled in the bags ore
connected direct with extrusion line.
RIVE : 3 Phase, 1440 rpm standard make electric motor fitted
with suitable reduction gear box of standard make throughelts as
per table
ontrol Panel : It includes voltmeter, Ammeter, temprature
indicators starter for control of electric motors. Buzzer is
rovided to indicate the mixing time. This control panel is air
tight to prevent any type of dust entrance in the panel.
tility
ectric supply 415 volts, 3 phase, 50 cycles ompressed Air : 5
cfm and working pressure at 70 ater pressure : 2-3 kgf/cm2
ECHNICAL SPECIFICATION
HEATING MIXER VESSEL CAPACITY COOLING MIXER VESSEL CAPACITY
MODELNO.
MIXERBLADEWINGS
VOLUMELts.
PVCCOMPOUND
Kgs.
ACTUALCOMPOUND
MIXING
DriverMotor(HP)
VOLUMELts.
PVCCOMPOUND
Kgs.
ACTUALCOMPOUND
MIXING
DM(
Turbo 40 6+1 100 50 40 20 235 117.5 94.26
Turbo 65 6+1 160 80 65 25 380 190 152.00
