Upload
khaled-eyad-almusa
View
250
Download
0
Embed Size (px)
Citation preview
1 ) Realistic Colors may be easily achieved without mixing colors or using brush. 2 ) Wide Colors Selection 3) Compatibility with other media such as colored pencil
Features :
Creating a Gradual Value Change
Select 3 to 5 markers from the same color range with values from light to dark
Apply the lightest color vertically several times to the entire area
While the lightest color is still wet, use the next darker color to cover approximately ( Two thirds ) of the area
Immediately use the first color and apply it vertically several times where the two colors meet.
While the second color is still wet, use the next darker color to cover the remaining One third of the area
Immediately Use the Second color to CLEAN THE LINE BETWEEN THE TWO COLORS
Using a colorless
[ BLENDER ] as the lighter color will give
the drawing a soft water color appearance
For a very dark shade you can flip the paper
and paint from the other side
Note : When you Render with markers on ( Ink Drawing ) if the ink is not waterproof, the ink will bleed on the marker color :
Technical Tips !
When Outlines of the original drawing are not readily visible, its is necessary to outline the entire drawing again with a black felt-tip pin
The lighter the value and the smaller the size of a drawing, the thinner the pen that should be used
Technical Tips !
To create strips apply the first coat of marker and wait 2 to 3 minutes for it to dry then use the same marker to draw over the desired area.
Technical Tips !
Applying two coats of a color, waiting between coats, will make the next darker value
4 4 5
4 4 5
Technical Tips !
Create a marker chart with spectrum selection and good range of values for quick reference
Technical Tips !
If a marker does become dry, it may be rejuvenated by adding a few drops of lighter fluid rubber cement thinner, or Toluene. This will somewhat reduce the intensity of color
Technical Tips !
Never throw away old markers. Dry markers can often be used to make lighter values and special effects
Technical Tips !
Use index cards, masking tape, or other appropriate material as a frisket, or mask, for a smooth straight-lined look
Technical Tips !
Use a white colored pencil or Pelican graphic white ink to
add highlights of
necessary
Technical Tips ! In order to achieve a shiny appearance on flat surfaces, use vertical strokes of the same color of the object being reflected