Macropus sap integration between ecc6 and crm through rfc

Document Control

Owner: Raghu Status:completed Draft

Revision History

Version Description of Change Date Author

1.0 Integration between ECC6 and CRM through RFC Connection

13/10/2010 raghu

Table content

1.Overview...........................................................................................................................32. Integrate crm with ecc6 through rfc connection..............................................................3

1. Overview

Configure STMS in between two systems by logging in to 000 clients, in both systems.

Creating logical systems and assign logical systems to clients in both systems Establish rfc connection from ecc6 to crm by using t-code sm59

2.Integrate crm with ecc6 through rfc connection Configure STMS in between two systems by logging in to 000 clients, in

both systems.

Enter username and password in 000 client of ecc6

Execute stms

Click on overview. It opens below screen

Click on save

Again logging in 000 client of crm system

Execute stms

Click on overview

Continue

Save. Then it will open below screen

Again logging in 000 client of ecc6 and then execute t-code stms

Click on overview

Select crm system

Click on approve

Click on Yes. It shows below screen

Both are in active state now

Go back

Again check crm status by executing t-code stms in crm system

So in above screen it shows crm is virtual system and ecc6 is domain controller

Creating logical systems and assign logical systems to clients in both systems

Execute t-code sale in ecc6

Define logical system

Continue

New entries

Save

Create own request

Save

Continue

Go back

Assign logical system to 100 client of ecc6

Same as above define and assign logical system in crm system also

Sale

Continue

Select 800

Assign logical system to the required client from where we have login remotely

Establish rfc connection from ecc6 to crm by using t-code sm59

Execute Sm59

Click on create

Give rfc description

Click on save

Give host name and system number of source system

Go to login & security tab and enter login parameters for remote login from one system to another system (from crm to ecc6)

Click on save

Continue

Again save

Hit on remote logon to test connection then it will enter into source system

Click on start sap easy accessThen it Is remotely login into ecc6 system