View
233
Download
1
Category
Preview:
Citation preview
Anypoint Lessons#01 – Hello, World!
Step 01 – Create a new project
Step 02 – Insert the name of your project
Step 03 – This is your empty canvas. Let’s drag a HTTP connector.
Step 04 – This is the connector and your configurations.
Use the configurations as default.
Step 05 – Insert the SET Payload connector. This is where you write your message (“Hello, world!”)
Step 06 – Insert a logger. This way you can monitore your application on the console too.
Step 07 - Run your Project.
Step 08 – Execute your application on your browser. Use the adress of the http connector configuration.
You can see the result on your console too.
See you next time!
Recommended