View
1.072
Download
1
Category
Preview:
DESCRIPTION
The
Citation preview
Connectivity test
Week 12
Get ready the multi-meter
1. Turn the switch to measure ohm (x10)
2. Short the two probes to test that the multi-meter is working properly
3. Check that the needle will swing towards the right
Chip holder – test short circuit
1. One probe on pin 1 2. Another probe on copper side but at a distance
3. Confirm short circuit
4. Continue to pins 2 - 14
Chip holder – test open circuit 11. Place the two probes on adjacent tracks
2. Confirm open circuit
3. Repeat on the next two tracks
Chip holder – test open circuit 2
1. Place the two probes across the chip holder
2. Confirm open circuit
3. Repeat on the next two tracks
Wire – test short circuit
2. Check that the needle will swing towards the right
1. Place the two probes on the tracks with the wires
Wire – test open circuit
2. Confirm open circuit
1. Place the two probes on adjacent tracks next to the wire track
Visual check
Good: Solder on both sides of ALL pins
Good: No solder on the gut
Visual check
Can improve: Partially not cover with solder
Can improve: Solder on the gut
The End
Recommended