View
2
Download
0
Category
Preview:
Citation preview
Summary
The bracket was designed to hold a folding ladder. Theres a small lip at theend of the bracket to keep the ladder in place.
Household > Other House equipment
ladder bracket abs
The orientation of the bracket it to increase its strength. It could beoriented on its back to print without support if the load on the bracket wasgoing to be minimal.
The profile is set up for ABS So please bear this in mind if you are using adifferent filament.
crammers
Simple Bracket
VIEW IN BROWSER
updated 29. 4. 2020 | published 29. 4. 2020
3D M
ODEL
ONLY
Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES
95.4 KBupdated 29. 4. 2020
The Author has not uploaded any print files.Try to search in User print files section or generate and upload yourown.
License
This work is licensed under a Creative Commons (4.0 International License)
Attribution-NonCommercial
✖ | Sharing without ATTRIBUTION ✔ | Remix Culture allowed ✖ | Commercial Use ✖ | Free Cultural Works ✖ | Meets Open Definition
folding-ladder-bracket.3mf
Recommended