View
6
Download
0
Category
Preview:
Citation preview
Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES
Summary
I lost the plastic peg that fits in the top of the guitar so I made my own! Isplit the model down the middle to orient the layers perpendicular to thepulling forces of the peg. Glued the halves together and it works perfect.
Toys & Games > Other Toys & Games
xbox fender controller guitar rockband
Split the model in half laying down and glue halves together
Since the peg is going to be pulled, the best way to print the piece ishorizontally to increase the strength.
Printed in Galaxy Black PLA at 215/60
No supports/rafts needed unless it struggles to stick.
P Patrick Dib
Rock Band XboxOne ControllerStrap Peg
VIEW IN BROWSER
updated 17. 3. 2020 | published 17. 3. 2020
3D M
ODEL
ONLY
266.5 KBupdated 17. 3. 2020
The Author has not uploaded any print files.Try to search in User print files section or generate and upload yourown.
License
This work is licensed under a Creative Commons (4.0 International License)
Attribution-NonCommercial
✖ | Sharing without ATTRIBUTION ✔ | Remix Culture allowed ✖ | Commercial Use ✖ | Free Cultural Works ✖ | Meets Open Definition
rockband-guitar-strap-peg.stl
Recommended