X431Actual Measurement 2013 Land Rover New Freelander-2 ... · 01-12-2017  · Land Rover...

【X431Actual Measurement】2013 Land Rover New Freelander-2 Fuel oil water cut Check the reset operation method 2016-05-06 golo官微

Land Rover Freelander-2 Diesel Car，2013，VIN=SALFA2BD7EH3*****。 Engine trouble light, sometimes difficult to enter the factory maintenance。After replacing the diesel oil and drainage treatment, the fuel - water - water testing will be carried out.

Operation Method

1. Select Land Rover V32.82 above ,see pic1;

图1 2. Prompt the info of operator，confirm the car model, see pic 2；

3. Check the vehicle information and click "yes" to continue,see pic3；

4. Select“Special Function”；

pic2

pic3

5. Select "fuel oil water test reset". After drainage, the procedure is to be performed to reset the distance and distance, which is related to monitoring the water in fuel. Before running this routine procedure, water must be emptied manually from the fuel system. Then click ok to continue, as shown in figure 4;

pic4

6.Switch on the ignition，Click “Confirm” to continue，see pic5；

pic5

7. In this process, the "fuel water content detection reset", click "ok" to continue, as shown in figure 6;

pic6 8.The fuel oil moisture detection reset is completed, and click "ok" to continue, as shown in figure 7;

pic7 9. Press the button to close the ignition switch (position 0) and click "ok" to continue, figure 8

pic8 10. Press the prompt to turn on the ignition switch (position 2) and click "ok" to continue, see 9

pic9 11. Note that the next step will clear all of the vehicle failure codes. Is it going to continue? Click "yes" to continue, as shown in figure 10;

pic10 12. Press the prompt to turn off the ignition switch (position 0) and click "ok" to continue, as shown in figure 11;

pic11 13. Press the prompt to open the ignition switch (position 2) and click "ok" to continue, as shown in

figure 12;

pic12 14. The prompt shows that "control module program completes successfully", and click "ok" to continue, as shown in figure 13;

pic13 15. Prompted to close the ignition switch (position 0) and click "ok", as shown in figure 14. At this point, special functional fuel water content detection reset.

pic14