Welcome to training on Best Management Practices for Erosion and Sediment Control

Welcome to training on Best Management Practices for Erosion and Sediment Control

Welcome to training on Best Management Practices for Erosion and Sediment Control

ScheduleSchedule Module Time Activity

1 8:00-8:45 Introduction

2 8:45-9:30 Erosion Fundamentals

9:30-9:45 Break

3 9:45-11:15 BMPs-Soil Stabilization

5 11:15-12:00 BMPs-Non Storm Water

12:00-1:00 Lunch

4 1:00-2:15 BMPs-Sediment Control

6 2:15-3:00 Design

3:00-3:15 Break

7 3:15-4:00 Construction

8 4:00-4:45 Maintenance

4:45-5:00 Training Closeout

Interaction with MDT ExpertiseInteraction with MDT Expertise

Construction and Environmental staff familiar with MDT erosion and sediment control issues and the development of the new manuals are attending this training

They are available to answer questions and provide interpretation of the material presented

Discussion time will be allowed at the end of each module

Your InstructorYour Instructor Stuart Jennings

Montana State University

Reclamation Research Unit

www.montana.edu/reclamation

Module 1: BMP Manual Overview and Regulatory Considerations

Module 1: BMP Manual Overview and Regulatory Considerations Erosion and Sediment Control Best Management

Practices: Field Manual

Prepared for:

Montana Department of Transportation

Research Section

2701 Prospect Avenue

PO Box 201001

Helena MT 59620-1001

Prepared by:

CDM

34 North Last Chance Gulch

Suite 104

Helena, MT 59601

February 2003

What is a BMP?

Why are BMPs important?

What is contained in the new MDT BMP Manual?

What permit is required for a construction site?

Learning ObjectivesLearning Objectives

Definitions—What is a BMP?Definitions—What is a BMP?

BMP-Best Management Practice for temporary erosion control

ESC-Erosion and Sediment Control

Why do we need BMPs?Why do we need BMPs?

The Clean Water Act (1972)

1996 National Water Quality Impairment Survey

Polluted runoff is a leading source of water degradation

Total Maximum Daily Loads (TMDL)

Decrease highway maintenance costs

How do we know how to select the appropriate BMP?How do we know how to select the appropriate BMP?

BMP Manual and Field Guide

Evaluation of site conditions

Experience

Training

BMP Tools and Resources BMP Tools and Resources

BMP Manual

BMP Field Guide

BMP Course and Notes

Websites

• EPA Stormwater Program http://cfpub1.epa.gov/npdes

/stormwater/swphase2.cfm

• DEQ Water Protection Bureauhttp://www.deq.state.mt.us/wqinfo/MPDES/Index.asp

Purpose of the Manual and Field GuidePurpose of the Manual and Field Guide

BMP Resources: provide technical and process-related BMP information

• BMP selection

• BMP specifications

• BMP integration with construction design

• Regulatory requirements

Goals of the BMP Training CourseGoals of the BMP Training Course

Provide overview of new BMP manual

Promote understanding of regulatory requirements, inspection criteria, and penalties

Help improve BMP selection and implementation

Provide an experience forum for case studies: what works and doesn’t work

Course Components (Modules)Course Components (Modules)

BMP Manual Overview and Regulatory Considerations

Erosion, Sediment, and Vegetation Fundamentals

Soil Stabilization BMPs (Group 1)

Sediment Control BMPs (Group 2)

Other BMPs (Group 3)

BMP Selection Criteria and Design Process

Construction and Implementation of SWPPP

BMP Inspection, Maintenance, and Removal

Montana Law and Storm Water PermittingMontana Law and Storm Water Permitting

Montana Code Annotated (MCA) 2001Montana Code Annotated (MCA) 2001

TITLE 75. ENVIRONMENTAL PROTECTION CHAPTER 5. WATER QUALITY

(29) (a) "State waters" means a body of water, irrigation system, or drainage system, either surface or underground.      (b) The term does not apply to:      (i) ponds or lagoons used solely for treating, transporting, or impounding pollutants; or      (ii) irrigation waters or land application disposal waters when the waters are used up within the irrigation or land application disposal system and the waters are not returned to state waters.

Montana Code Annotated (continued)Montana Code Annotated (continued)

75-5-101. Policy. It is the public policy of this state to:      (1) conserve water by protecting, maintaining, and improving the quality and potability of water for public water supplies, wildlife, fish and aquatic life, agriculture, industry, recreation, and other beneficial uses;      (2) provide a comprehensive program for the prevention, abatement, and control of water pollution.

Montana Code Annotated (continued)Montana Code Annotated (continued)

25) (a) "Pollution" means:      (i) contamination or other alteration of the physical, chemical, or biological properties of state waters that exceeds that permitted by Montana water quality standards, including but not limited to standards relating to change in temperature, taste, color, turbidity, or odor; or      (ii) the discharge, seepage, drainage, infiltration, or flow of liquid, gaseous, solid, radioactive, or other substance into state water that will or is likely to create a nuisance or render the waters harmful, detrimental, or injurious to public health, recreation, safety, or welfare, to livestock, or to wild animals, birds, fish, or other wildlife.      (b) A discharge, seepage, drainage, infiltration, or flow that is authorized under the pollution discharge permit rules of the board is not pollution under this chapter.

Pollution AuthorizationPollution Authorization

Storm Water Permitting AuthorityStorm Water Permitting Authority

Tribal Lands

(EPA)

All other lands within the State of Montana (Montana Department of Environmental Quality)

General Permit for Storm Water Discharge associated with construction Activity (obtained from DEQ)

General Permit for Storm Water Discharge associated with construction Activity (obtained from DEQ)

Part I. Coverage provided by General Permit

Part II. Effluent Limitations and Special Conditions

Part III. Monitoring, Reporting, Record Keeping

Part IV. Storm Water Pollution Prevention Plan (SWPPP)

Part V. Standard Conditions

General Permit SummaryGeneral Permit Summary

Identify areas that may contribute pollutants to surface waters

Ensure that minimal sediment reaches surface water using erosion and sediment control measures

Develop and implement a Storm Water Pollution Prevention Plan (SWPPP)

General Permit Part I. Coverage provided General Permit Part I. Coverage provided

Construction disturbances >1 acre require permitting

All discharges must be in accordance with the SWPPP

Notice of Intent (NOI) Package must be submitted to DEQ

NOI Package contains standard NOI form, SWPPP and application fee

NOI FormNOI Form

Name and address of operator(s)

Contact person telephone number

Project name and location

Name of receiving surface water

Construction schedule

Estimated area of disturbance

Located on pages C-2 and D-2 of Reference Manual

General Permit Part II. Effluent Limitations and Special ConditionsGeneral Permit Part II. Effluent Limitations and Special Conditions

All discharges to surface water must be composed entirely of stormwater

No discharge of process wastewater

Stormwater discharges must not cause or contribute to water quality standard violations

BMPs must be maintained in accordance with SWPPP

General Permit Part III. Monitoring, Reporting, Record KeepingGeneral Permit Part III. Monitoring, Reporting, Record Keeping

All erosion and sediment control measures must be inspected and maintained by the operator at least once every 14 days and within 24 hours of any storm event of 0.5 inches or greater

DEQ must be notified in writing within 2 days of the detection of any significant spill or release

Copy of SWPPP must be available on-site

Uncontrolled releases must be documented

“significant sediment”“significant sediment”

Mud, dirt, sediment, or similar material exceeding 1.0 cubic foot in volume which is deposited in any area of 100 square feet or less on public or private streets or property adjacent to the construction site.

General Permit Part IV. Storm Water Pollution Prevention Plan (SWPPP)General Permit Part IV. Storm Water Pollution Prevention Plan (SWPPP)

Operator shall develop a SWPPP and submit a copy at the same time as the NOI form

Operator shall implement the SWPPP at the time construction activity commences

Operator is responsible for for ensuring SWPPP requirements stated in the General Permit are complied with

Blank SWPPP located in Appendix E of the Reference Manual

Example SWPPP located in Appendix F of the Reference Manual

SWPPP (continued)SWPPP (continued)

The SWPPP may include any erosion and sediment control measures or BMPs including but not limited to the use of sediment basins, berms, barriers, filter strips, covers, diversion structures, seeding, and sodding

The SWPPP must include maps(s) indicating:The SWPPP must include maps(s) indicating:

Areas of disturbance

Drainage patterns

Location of BMPs

Revegetation areas

Location of Impervious structures

Location of all surface waters

Location of 100 year floodplain

SWPPP (cont.)SWPPP (cont.)

Must include BMP description

Must preserve existing vegetation

None of temporary BMPs shall be removed until permanent vegetation and site stabilization has taken place

BMPs must minimize or prevent “significant sediment” from leaving the construction site

Notice of Termination (NOT) Form Notice of Termination (NOT) Form

Where a site has been finally stabilized the operator of a site shall submit a Notice of Termination to DEQ

“final stabilization” means all soil disturbing activities have been completed and a vegetative cover has been established with a density of at least 70 percent of the pre-disturbance levels

Located on page G-2 and H-2 of the Reference Manual Appendices

Storm Water ComplianceStorm Water Compliance

DEQ expects all permit holders to be in compliance with the provisions of the General Permit and the site specific SWPPP

DEQ will conduct inspections

DEQ will issue fines for non-compliance

Fines for non-complianceFines for non-compliance

75-5-631. Civil penalties (1) In an action initiated by the department to collect civil penalties against a person who is found to have violated this chapter or a rule, permit, effluent standard, or order issued under the provisions of this chapter, the person is subject to a civil penalty not to exceed $25,000. Each day of violation constitutes a separate violation.

Fines for non-complianceFines for non-compliance

75-5-632. Criminal penalties. A person who willfully or negligently violates 75-5-605 or any pretreatment standard established pursuant to this chapter is guilty of an offense and, upon conviction, is subject to a fine not to exceed $25,000 per day of violation or imprisonment for not more than 1 year, or both. Following an initial conviction under this section, subsequent convictions subject a person to a fine of not more than $50,000 per day of violation or imprisonment for not more than 2 years, or both.

Montana DEQ Contact InformationMontana DEQ Contact Information

On the Web (http://www.deq.state.mt.us/wqinfo/MPDES/StormwaterConstruction.asp)

On the phone

Water Protection Bureau 444-3080

Brian Heckenberger 444-5310

Spencee Willett 444-0420

Gail Faber 444-5338

BMPs ExamplesBMPs Examples

Inlet Protection

BMPs ExamplesBMPs Examples

Silt Fence used to protect wetland No BMPs in place, wetland below

BMPs Examples BMPs Examples

BMPs Examples BMPs Examples

Aggregate stabilized construction entrance

Muddy construction entrance

Consequences of BMPsConsequences of BMPs

Consequences of BMPsConsequences of BMPs

Module 1 ReviewModule 1 Review

BMPs are required at construction sites larger than 1 acre

MDT has prepared a new BMP Manual

DEQ Requires a permit for each construction project

A site-specific SWPPP must be developed and implemented

BMPs must be maintained until the site is stable