View
225
Download
0
Category
Preview:
Citation preview
www.bevsinfo.com . Email:sales@bevsinfo.com
Thickness
Paint Inspection Gauge(PIG)
Introduction:
Using Principle:
Technical Specification:
Cut Angle Range(μm) D Factor(μm)Cutter
45°
63.4°
84.3°
No.1
No.2
No.3
10-900
20-1800
2-180
20
10
2
Standard:
ASTM D4138, DIN 50986, ISO 2808
o ab e ga e a p:
www.bevsinfo.com . Email:sales@bevsinfo.com
Operating Steps:
Order Information:
BEVS 1707 Paint Inspection Gauge
Measurement Principle:
Step Illustration Description
Prepare the inspecting area.
Draw a line with the marker penon the surface.
Cut the coating vertically and make sure it is lacerated.
Read the graduation-scale withthe microscope to attain thickness.
1
2
3
4
Order Information of Accessories:
BEVS 1707 PIG/1 Cutter No.1
BEVS 1707 PIG/2 Cutter No.2
BEVS 1707 PIG/3 Cutter No.3
Recommended