SportPort Hockey. SportPort Athletic Equipment Storage Systems Developed by: Kenton Schram – Owner...

SportPort

Hockey

SportPortAthletic Equipment Storage Systems

Developed by:

Kenton Schram – OwnerBesben Inc.

10331 – 56 Street, Edmonton, AB T6A 2J3Phone: 780-232-4810 Email: besben@shaw.ca

SportPort Systems - Why?

• SportPort Systems - developed to address three problems common to storing equipment:1. Odour/Health• Commonly known as “Locker Room Odour”• Fungi & Bacteria growth can pose a health risk

2. Clutter• The contents of a hockey bag take up scarce garage or

basement floor space3. Ambivalence• Family athletes, commonly drop their gear wherever it

lands when they arrive home

1 - Odour & Health

• The Cause:– Published research papers reveal perspiration soaked

athletic apparel promotes growth of fungi and bacteria which:• Yield unpleasant odours• Pose health risks• Lead to premature equipment

deterioration

• The Simple Solution:– Spread equipment out to promote air circulation to:

• Completely dry equipment immediately after use• Inhibit the growth of biologicals

2 - Clutter

• The Problem:– Few families have specialized equipment storage systems

• Existing systems are primarily floor based occupying scarce basement or garage floor space

• Equipment stored in multiple locations can be forgotten on game day

• The Solution:– SportPort Systems

• Wall mounted on finished wood stud walls• Custom hanger brackets accept equipment to open & distribute it

promoting rapid drying– Keeps everything in one place for easy access; hockey version

accommodates: skates, pads, helmet, pants, gloves & sticks

3 - Ambivalence

• The Problem:– Competitive Systems are utilitarian in design• Equipment hangs in haphazard manner• Awkward to fill and retrieve from• Unappealing to look at full or empty

• The Solution:– SportPort• Sport Specific Wall Mounted Systems

– Appealing award or crest shape– Specially designed hangers for every piece of gear

Working Prototype Package

• Dimensions– Height 24”– Width 24”– Thickness 2 ½”

• Graphics– Front

• Board with equipment– Back

• Package Contents• Assembly Directions

(Finished versions will be fully bilingual)

Working Prototype BackAs Packaged

• Hanger brackets nested in back of board inside package

Note 2-screws on the vertical centerline for mounting.

Assembled Working Prototypewith Hanger Brackets

• Assembly Includes:– Base Board– Attached Snap-in hanger

brackets

Working Prototype - with Gear

• Equipment Accommodated– Top

• 1-Helmet• 1-Pair Gloves

– Centre• 1-Set Shin Pads• 1-Set Elbow Pads• 1-Pair Skates• 2-Sticks

– Bottom• 1-Pants• 1-Shoulder Pads

Thank You for Your Interest

For Further Information Please Contact

Besben Inc.Kenton Schram - Owner

10331 – 56 Street, Edmonton, AB T6A 2J3Phone: 780-232-4810 Email: besben@shaw.ca