View
2
Download
0
Category
Preview:
Citation preview
GRUNDFOS DATA BOOKLET
SP5A- 4N 2.2kW 1x220V 50Hz Grundfos Pump 5202104
Thank you for your interest in our productsPlease contact us for more information, or visit our websitehttps://www.lenntech.com/grundfos/SPFAM/5202104/SP-5A-4N.html
info@lenntech.comtel. +31-15-261.09.00fax. +31-15-261.62.89
BE > THINK > INNOVATE
Printed from Grundfos Product Centre [2018.02.043]
Position Qty. Description1 SP 5A-4N
Note! Product picture may differ from actual product
Product No.: 5202104
Submersible borehole pump, suitable for pumping clean water. Can be installed vertically orhorizontally. All steel components are made in stainless steel, EN 1.4401 (AISI 316), that ensures highcorrosive resistance.The pump is fitted with a 2.2 kW MS4000 motor with sand shield, mechanical shaft seal,water-lubricated journal bearings and a volume compensating diaphragm. The motor is a canned typesubmersible motor offering good mechanical stability and high efficiency. Suitable for temperatures upto 40 °C.The motor is not fitted with a temperature sensor. If temperature monitoring is desired, a Pt1000 sensorcan be fitted.The motor is for direct-on-line starting (DOL).
Further product detailsThe pump is suitable for applications similar to the following:
- raw-water supply- irrigation- groundwater lowering- pressure boosting- fountain applications- mining applications- off-shore applications.
The Grundfos SP pump is renowned for its high efficiency and already complies with the requirementsof the Minimum Efficiency Index, and therefore Grundfos is amongst the best in class withinsubmersible pumps.
PumpAll pump surfaces that are in contact with pumped liquids are made in stainless steel which makesthem corrosion- and wear-resistant. The corrosion diagram below shows the capabilities of the pumpand motor in relation to the temperature in Celsius (y-axis) and the concentration of chloride in ppm(x-axis).
Printed from Grundfos Product Centre [2018.02.043]
The elastomer parts in the pump are made of NBR (Nitrile-Butadiene Rubber) and TPU (ThermoplasticPoly-Urethane) which offers good wear resistance and long service intervals.
The top chamber features a built-in non-return valve to prevent backflow and reduce the risk of waterhammer.The suction interconnector is fitted with a strainer to prevent large particles from entering the pump. Thesuction interconnector is designed to comply with NEMA standards for motor mounting/dimensions.
MotorThe stator is hermetically encapsulated in stainless steel and the windings are embedded in polymercompound. This results in high mechanical stability, optimum cooling and reduces the risk of shortcircuits in the windings.The shaft seal faces are SiC/SiC. The material combination gives good performance when abrasiveparticles (sand) is present. Together with the shaft seal housing, the sand shield forms a labyrinth seal,which during normal operating conditions prevents penetration of sand particles into the shaft seal. Thisshaft seal is drinking water approved.The motor can be fitted with a Pt100 or Pt1000 sensor that together with a control unit ensures that themaximum operating temperature conditions are not exceeded.
Liquid:Pumped liquid: WaterMaximum liquid temperature: 40 °CMax liquid t at 0.15 m/sec: 40 °CLiquid temperature during operation: 20 °CDensity: 998.2 kg/m³
Technical:Speed for pump data: 2900 rpmRated flow: 5 m³/hRated head: 16 mShaft seal for motor: SIC/SICApprovals on nameplate: CE,EACCurve tolerance: ISO9906:2012 3BMotor version: T40
Materials:Pump: Stainless steel
EN 1.4401Impeller: Stainless steel
EN 1.4401Motor: Stainless steel
DIN W.-Nr. 1.4539AISI 904 L
Installation:Pump outlet: Rp1 1/2Motor diameter: 4 inch
Electrical data:Motor type: MS4000Type of motor: CSCRRated power - P2: 2.2 kWMains frequency: 50 HzRated voltage: 1 x 220-230 VRated current: 14,6-14,0 AStarting current: 540-600 %Cos phi - power factor: 0,96-0,96Rated speed: 2850-2870 rpmStart. method: direct-on-lineEnclosure class (IEC 34-5): IP68Insulation class (IEC 85): FBuilt-in temp. transmitter: no
Others:Minimum efficiency index, MEI ≥: 0.56
Printed from Grundfos Product Centre [2018.02.043]
Position Qty. DescriptionErP status: EuP Standalone/Prod.Net weight: 25.1 kgGross weight: 26.9 kgShipping volume: 12 m³
Printed from Grundfos Product Centre [2018.02.043]
5202104 SP 5A-4N 50 HzH
[m]
0
2
4
6
8
10
12
14
16
18
20
22
24
26
28
Q [m³/h]0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 5.5 6.0 6.5
eta[%]
0
10
20
30
40
50
60
70
80
90
100
SP 5A-4N, 1*230 V, 50Hz
P[W]
0
100
200
300
400
500
600
700
800
900
1,000 P1
P2
Printed from Grundfos Product Centre [2018.02.043]
H[m]
0
2
4
6
8
10
12
14
16
18
20
22
24
26
28
Q [m³/h]0 0.5 1.5 2.5 3.5 4.5 5.5
eta[%]
0
10
20
30
40
50
60
70
80
90
100
SP 5A-4N, 1*230 V, 50Hz
P[W]
0
200
400
600
800
1,000 P1
P2
857
573
284
101
95
Rp1 1/2
Grey
Brown
Black
Yellow/green
3
2
1 L1
N
PE
L
N
SA-SPM 3
M1
Description ValueGeneral information:Product name: SP 5A-4NProduct No: 5202104EAN number: 5700390238223Technical:Speed for pump data: 2900 rpmRated flow: 5 m³/hRated head: 16 mStages: 4Shaft seal for motor: SIC/SICApprovals on nameplate: CE,EACCurve tolerance: ISO9906:2012 3BModel: A
Valve: pump with built-in non-returnvalve
Motor version: T40Materials:Pump: Stainless steel
EN 1.4401Impeller: Stainless steel
EN 1.4401Motor: Stainless steel
DIN W.-Nr. 1.4539AISI 904 L
Installation:Pump outlet: Rp1 1/2Motor diameter: 4 inchLiquid:Pumped liquid: WaterMaximum liquid temperature: 40 °CMax liquid t at 0.15 m/sec: 40 °CLiquid temperature during operation: 20 °CDensity: 998.2 kg/m³Electrical data:Motor type: MS4000Type of motor: CSCRApplic. motor: NEMARated power - P2: 2.2 kWMains frequency: 50 HzRated voltage: 1 x 220-230 VRated current: 14,6-14,0 AStarting current: 540-600 %Cos phi - power factor: 0,96-0,96Rated speed: 2850-2870 rpmStart. method: direct-on-lineEnclosure class (IEC 34-5): IP68Insulation class (IEC 85): FMotor protec: NONEThermal protec: externalBuilt-in temp. transmitter: noMotor No: 79214607Others:Minimum efficiency index, MEI ≥: 0.56ErP status: EuP Standalone/Prod.Net weight: 25.1 kgGross weight: 26.9 kgShipping volume: 12 m³
101
95
Rp1 1/2
Printed from Grundfos Product Centre [2018.02.043]
5202104 SP 5A-4N 50 Hzcos phi
eta
0.0
0.2
0.4
0.6
0.8
P2 [kW]0 0.2 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8 2.0 2.2 2.4 2.6 2.8 3.0
I[A]
0
4
8
12
16
SP5A-4N + MS4000 2.2 kW 1*230 V, 50 Hz
eta
cos phi
I
n[rpm]
2000
2200
2400
2600
2800
P1[kW]
0.0
1.0
2.0
3.0
4.0n
P1
Printed from Grundfos Product Centre [2018.02.043]
5202104 SP 5A-4N 50 Hz
Note! All units are in [mm] unless others are stated.Disclaimer: This simplified dimensional drawing does not show all details.
857
573
284
101
95
Rp1 1/2
Printed from Grundfos Product Centre [2018.02.043]
5202104 SP 5A-4N 50 Hz
Note! All units are in [mm] unless others are stated.
Gre
y
Brow
n
Blac
k
Yello
w/g
reen
321L1 N PE
L N
SA-S
PM 3
M 1
Disclaimer: The information about the Grundfos pump in this document may be outdated.Data may be subject to alterations without further notice.Please contact us to verify the data above is still accurate/up-to-date.
All information is copyright Grundfos.
info@lenntech.comwww.lenntech.comtel. +31-15-261.09.00fax. +31-15-261.62.89
Recommended