PROBLEM HOW TO EASILY WATERPROOF FOUNDATIONS AND VERTICAL WALLS WITH REDUCED GAS CONSUMPTION (in the...

PROBLEMHOW TO EASILY WATERPROOF

FOUNDATIONS AND VERTICAL WALLS WITH REDUCED GAS CONSUMPTION

(in the waterproofing of foundation walls and vertical surfaces the applyer works in difficult conditions.

Standard roofing membranes adhere slowly and the applyer has to hold them up till their cooling,

otherwise they come off)

SOLUTION

• Polymer-bitumen elastoplastomeric waterproofing membrane reinforced with a “non-woven” single strand spunbond polyester and coated on its lower face with a heat-adhesive mix, having a very high “Hot Tack” (initial adhesion), for waterproofing of foundation walls and vertical surfaces.

VERTIFLEX SUPERTACK

LOWER FACE WITHPOLYETHYLENE FLAMINA

EMBOSSED UPPER FACEWITH POLYETHYLENE FLAMINA

Thick single strand “non-woven” spunbond polyester reinforcement

Adhesion of Tack compound

The high “Hot-Tack” of the lower face compound makes the difference !!

Elongation of the TACK compound

PEEL RESISTANCE AT 70°C

STANDARD MEMBRANE

VERTIFLEX VERTIFLEX SUPERTACK

PEEL TEST AT 70°C

25 N/5cm 37 N/5cm 73 N/5cm

ADVANTAGES

• - VERTIFLEX SUPERTACK/P reduces the gas consumption

• - VERTIFLEX SUPERTACK/P reduces the labour cost

• - VERTIFLEX SUPERTACK/P sticks quicker

a t t a c k s

the Walls !!