View
214
Download
0
Category
Tags:
Preview:
Citation preview
Presenter : Chien-Hung Chen
Tsung-Cheng LinKuan-Fu Kuo
20090331
EICE team
Open On-Chip DebuggerCh6. Design and Architecture
Software Modules Configuration Management and CLI Module JTAG Module Target Module Flash Module GDB Module
2
3
The daemon is the first part that is initialized,
and controls the remaining components
The program configuration by evaluating the command line arguments,
Accesses the hardware being debugged
The GDB module is invoked after the
daemon
The Flash module is only accessed via the command interface
The configuration To configure the debugger To describe target initialization
The LGPL licensed libcli implements a telnet server
The libcli library defines two modes。 An execution mode。 A configuration mode
Every module registers its configuration commands with the CLI module
4
High-level command Read or write test data registers and control the TAP
state machine
Low-level command Directly modify the JTAG signals(bit-bang operation)
CLI commadns To adjust the JTAG device speed To read the IDCODE
5
Defines CLI commands useful for all target implementations The startup mode The target’s endianess Control the target execution
。A user may halt, single-step, resume, or reset the target
Poll the target state Read memory Write memory Load binary file Dump binary file
6
Breakpoint Handling Software breakpoint
。A target dependent instruction code has been written into the target’s memory
Hardware breakpoint
Watchpoint Handling Like breakpoints
9
The Flash modules uses the target module to access memory.
The module registers CLI commands that configure the flash Configure the size of one flash chip. Configure the width of a single flash chip. Configure the width of the bus that connects a flash
bank to the microcontroller. Probe a given address for the presence of a flash bank
that matches the configuration.
10
Print information about the blocks of a flash bank at a given location. If the flash supports a protection mechanism, information about the protection state should be printed, too.
Erase a range of blocks on a flash bank at a given location.
Write a binary file at a selected offset on a flash bank at a given location.
11
Recommended